









Silicone Rubber Sheet,Heat Resistant, Heavy Duty,High Grade 60A,12 x 12 Inch, 1/25 Inch Thickness for DIY Gaskets, Pads, Seals, Crafts, Flooring,Cushioning of Anti-Vibration, Anti-Slip
-
Phoenix, AZ
> 24 hourThe product works but realize it is not actually 12 by 12. it is 1/16th inch short on both length and width. Unfortunately, I needed this product to be exactly 12 by 12, being a 16th of an inch short in both directions renders it useless for my purpose. Good product but realize like others have said, its not square and its smaller than 12 by 12.
-
Jay peryot
> 24 hourThe other one is in the trash-burned
-
Ron
> 24 hourI ordered the 1/8 version of this silicone but what I got was slightly less thick. Also there were a lot of inclusions in the piece I received. One side is shiny and somewhat sticky as I would expect from silicone but the other side is matte and slippery. Overall not that great of quality.
-
Mark SH
> 24 hourEasily cut with gasket cutter. Seems to work fine and should be able to withstand weathering. Sheet will provide materials for many more gaskets.
-
ArifMah
> 24 hourI wish i had checked the tkickness. It is too thin to make the washers.
-
FuntasticOne
> 24 hourI purchased this rubber mat to cut four corners to hold up a plant, which I inserted pot into a pot. I noticed that even though the top pot was larger, it would still slip and turn. This rubber mat is perfect to keep my potted plant in place. Plus, it is heat and water resistant. The black mat camouflages nicely against my dark blue outer pot. I am pleased.
-
Trekker140
> 24 hourBought to be gasket for hobby paint jars that had no gaskets for the lids. Using for enamel paints. Cut and installed flat in the cap, to the edge. After a week of storage of enamel paint, when cap was removed, the rubber material bowled. Unable to reuse since it was bowled and was thinner than when installed, unable to get seal, had to cut new piece.
-
RP
> 24 hourWorked great for my project. As others have mentioned it’s not square.
-
Jake Stewart
> 24 hourWorks for what I needed it for
-
Angelina Tremblay DVM
> 24 hourI was using this to line a mold to melt plastic into different shapes. Its kind of pricy (since I had to cut it up) But it worked good in the oven at 350F