skineat 3 Pack Computer Case ATX Power On Off Reset Switch Cable with 2 x LED Light Light Red Green 27-inch ATX Case Front Bezel Wire (2-Pack)

I had to get a replacement bunch of switches for a PC case I broke almost every front panel connector for, and I found these. the Power switch conveniently was already molded for the power button and fit perfectly. the HDD LED works just fine, the Reset switch also worked perfectly fine. I could not for the life of me get either Power LED to work. Both sets didnt work. I had the correct Pinout, and I couldnt get anything out of either one. the power LED for my old case worked, but neither of these did.

The cables were a little tight for my large Tower computer case so I patched about 12 inches extra to my HDD LED cable and Reset Switch cables which were the only ones I needed at this time. The HDD LED bulb was twice as large as the original HDD LED that came with my computer case but I simply used a Soldering Iron to enlarge the hole and now it fits and works great. Nice and bright RED light. Very pleased with this purchase and product. Note: I didnt use the micro-switch since I replaced the Reset Switch with a much larger switch but use the cable and Reset switch connector instead.

Only had red and green LED lights, My case has red and clear. I can live with that. I am very happy, easy to install, Although I need some hot glue to hold down the switches. I think a low temp glue gun would be the best solution to hold down the LED wires and switches.

Satisfied with what I needed them for.

Buy it!

Ive not tried the switches as I did not need those, but they do click the way one would expect them to, so I would expect them to work if I had needed them. The LEDs on the other hand are what I needed and they do work well. The red LED is particularly bright and if you installing these on the outside of your case then expect yourself to cover the red LED with packing tape or something to dim it; it is very very bright. The green LED (for HDD activity) is fine and works well. I did not need to cover that with packing tape as the brightness on that was bot too bad and it only momentarily flashes when there is HDD activity. I installed the LED by drilling small holes in my case and pressing the lights snuggly into the holes. I used a drill bit that was slightly smaller than the LED bodies. The LEDs are elongated dome shaped with small lips at their base. The leads at the bottom are quite long but can be bent if needed. I wish they offered other colors besides the traditional red and green.

I had to get a replacement bunch of switches for a PC case I broke almost every front panel connector for, and I found these. the Power switch conveniently was already molded for the power button and fit perfectly. the HDD LED works just fine, the Reset switch also worked perfectly fine. I could not for the life of me get either Power LED to work. Both sets didnt work. I had the correct Pinout, and I couldnt get anything out of either one. the power LED for my old case worked, but neither of these did.

exelente

The only issue that I wish that this cable had was a different colored switchs for the power and reset buttons, other than that, these work great!

Performed as expected.