SpeTool Extra Long CNC Spiral Router Bits with Up Cut 1/8 inch Cutting Diameter, 1/4 inch Shank 3 inch Extra Long HRC55 Solid Carbide End Mill for Wood Cut, Carving

Work great cutting 1 inch wood on my cnc

Worked while it lasted, it didn`t last very long. 3 uses

this bit has worked very well so fare

In middle of cut with cnc in hard wood the bit broke where it makes the transition from 1/4 to 1/16

Works great but gets dull fast

Im glad I went with the extra-long bit. The bit that comes with the inlay kit works well but limits you to 1/4 temples and limits your inlay depth. The longer bit allows you to use 1/2 thick templates and still cut a 1/4 deep inlay. 1/4 template allows you to get 3/4 inlays.

While this long shank might get you a deeper cut in some places, the 1/8 cutting portion is only 1 inch long, widens right out. So dont expect to get deep into corners/along sides because youve only got a 1 inch cut depth before the shank hits the upper wall of the material, prevents you from going deeper on the edge.

After three uses this bit broke in half. I was using it on a routine cut and it broke in half. I am not satisfied with this bit

i took no more than 1/8 of material at a time but it broke on the second pass. i am never buying from these folks again.

I was using this to try to make some cutouts in 18mm (~3/4in) baltic birch plywood on my new CNC machine. My practice cuts on foam worked fantastically, and it initially cut cleanly on the plywood as well. However, the bit seemed to dull pretty quickly. I noticed it wasnt cutting cleanly on my 3rd or 4th run (feathered shavings, torn edges). I dont have another 1/8 bit, so I kept going, hoping to get through the 4 patterns needed to make to finish my project. I almost finished the first one when the bit bound up in the wood and jumped, causing the work product to move, and the CNC happily drove it right through the edge of my nearly complete cut. I started over, and at about 3/8 deep it bound up again; I hit the estop this time to save my work (Ill just rough cut it on the bandsaw and use a flush trim to clean up the edge), but when I looked the bit had snapped in two. I guess this is what I should expect for a $16 bit, and Im not that sad that the bit broke, but Im kinda pissed that I ruined so much work product; wood is expensive these days! I guess you get what you pay for, though for $16 Id expect to get more than 2 days worth of cutting out of it. The bit was probably only running for a total of 8 or 9 hours before it broke. Update: I contacted the manufacturer and asked for a replacement. I just received a 1/8 downcut bit in the mail that was broken on arrival... so not only was it broken, but they sent the wrong bit. At this point Im just cutting my losses, but I know not to purchase anything from this company again.