













SpeTool Extra Long Spiral Router Bit Down Cut 1/8 inch Cutting Diameter, 1/4 inch Shank 3 inch OVL HRC55 Solid Carbide End Mill for Wood Cut Carving Engrave
-
Jerry Davidson and Linda Davidson
> 24 hourGreat
-
Larry J Scott
> 24 hourCuts nice and clean
-
Brian Getz
> 24 hourBroke on the third pass on the MDF my students were cutting.
-
Erich Winkelmann
> 24 hourThis is a great bit for cnc use. Cuts great and the extra long reach is exactly what was needed. Will definitely buy again
-
Melissa New
> 24 hourBroke in first 4 min .1 DOC 45 in/min speed. I bought 2 because they were same day shipping and needed them ASAP and I was afraid one would break. Ran the second bit at .09 ODC and 40 in/min and it worked fine.
-
Chris Woolley
> 24 hourJust what I need for the project I am doing with my daughter
-
Aaron J.
> 24 hourThe bit snapped after routing out a few butterfly joints. Lasted less than an hour of use.
-
Christopher Seguin
> 24 hourReally like the length and reach however cutting even at slow feeds and shallow doc seemed to much. But just seems dull compared to other brands I’ve used.
-
Vicki Jones
> 24 hourBroke almost immediately and was cutting with its set specs listed...so so disappointing..
-
Kenneth B.
> 24 hourI ran this bit on my cnc machine at 60 inches per minute, pass depth of 0.1 inch spindle speed at 10,000 and carving oak 1/2 plywood it broke within a couple minutes. I didnt expect that.