Stainless Steel Cable Clamp -25PCS 1/4Inch Rubber Cushioned Insulated Clamp,Metal Hose Clamps,Tube Holder for Tube, Wiring,Pipe or Wire Cord Installation (1/4Inch-25PCS)

This is my second order of these clamps. With 30 in the package they cost about 40 cents - a good value. I got these to secure some new fuel lines on my Saab project. I used similar smaller clamps to secure the hood release cable. I like the stainless construction that should withstand corrosion and the rubber cushion holds securely. These are very easy to install with some self-tapping hex-head screws. I’m pleased with the quality and would order them again.

These turned out to be really nice. Large gage steel cable clamps in a variety of sizes with thick rubber boots to protect the cables. The install easily and the selection of sizes means you can snug up practically any cable or bunch of cables. Having the kit to pick and choose to see what fits best is a much better alternative than going back and forth to the hardware store for one piece. And likely cheaper than the gas you would spend to get a whole kit vs. one piece. No complaints at all about this products design or manufacture.

This multi-pack of partially rubberized steel clamps are a good value overall, offering multiple sizes so that you can fit what works for you. Check the sizes offered because the range tops out at a relatively narrow diameter. I find these useful for work on bikes, e.g. to secure racks, lights etc. to bike frames. The rubber protects the bike paint while giving a slightly better grip, but dont tighten the clamps too much. The steel seems to be good quality, and did not visibly show stress fracture with light deformation (which youll have to do when installing these). The rubber is good quality and completely covers the inside (i.e. its just one piece rather than two small pieces on each side). The only issue I have is that the metal edges are not finished very well and are quite sharp in some cases. If youre not careful, you might slice your fingers while working with these. I recommend using gloves with finger protection, or filing off the sharp edges first.

These clamps are solidly constructed. I am going to use them to run cat5 cabling in a non-climate controlled space. I like stainless steel as it will not develop surface rust in the high humidity my area regularly receives.

These are about what you would expect for one of these sets of cable clamps. Good quality overall, the steel section is good and sturdy and doesnt flex excessively. The rubber grommet seems to stay in place pretty well. This set offers a good variety of clamps, all sorted and easy to get to in the organizer. Much easier than a box full of hardware that most people have!

These are very sturdy hose clamps. They work well and are easily attached.

The Allwin stainless cable clamps are made in PRC (china). The clamps appear well made and come in a plastic box. I did not find any flawed clamps or missing cushions in the case. These are worth a try for the price.

I have been searching for these at my local stores and couldnt find them. I knew they existed as I had seen them somewhere before. I finally stumbled upon them on Amazon and am excited....lame I know. The ones pictured are the 1 3/4in size. They are a bit large for your typical broom handle, but I am going to be using them to store a survey pole that is 1 1/4in in diameter. I will be using these mounted to the side of a wooden survey truck box for quick access to one (or more) survey rods. Im sure you can think of many other uses for these!

I wanted these hose/cable clamps simply for cable management. I have a 240v electric vehicle charger and wanted to elevate the charging cable off the ground due to snow, slush and water. The clamps come in a variety of sizes so I measured the diameter of my cable and it was 3/4 diameter. I ordered the 3/4 cable clamps and they work perfectly. The cable fits into the clamp with just a slight bit of play which allows the cable to slide, if needed. I like that the clamps are advertised as being made of stainless steel so they should not rust and the sleeve is made of rubber so it is flexible and should remain flexible even in colder temps. The clamps do not come with screws or bolts simply because there are too many different surfaces to attach them to. One of the attached pics show how the clamps are packed and the other pic shows the clamps in use.

Good quality and great price