TCP Global Gravity Feed Sand Blaster Gun Kit - Hand Held Sand Blasting Spray Gun with 2 Ceramic Nozzle Tips and Air Regulator - Blast Abrasive Media, Soda, Bead, Walnut, Aluminum Oxide - Pneumatic

It was easy to setup and fill, seems to use a lot of media. Works pretty good for small jobs and light blasting. Light rust and paint come off fairly easily. Heavy pitted rust and old thick paint take some time and more media but it does work, just time consuming. If you can recover the used media that would be a plus, but thats a whole other project. Glasses and a face shield are a must because the stuff goes everywhere without a cabinet and stings when it hits your face, use proper PPE! Simple small sand blaster, it is what it is and for the price it works fine for me.

I have not used the nozzles as of yet. I gave them a 3 star as one of the nozzles had two chips out of the little flange that runs around the nozzle that acts as a stop. Since I will have an O-ring at that point I am sure they will work ok. I bought these as replacement nozzles for my Harbor Fright blaster, they seem to fit just fine. They had just a bit of harsh handling during the trip or where they were shipped from.

It is actually a pretty good product for the price. If you search here there are other ones but most are the same sold under different names, When i see that i avoid that product its typical junk so i went with this one and it was a good call it warks and i maed a cheap blasting cabinet out of a clear storage tote, toilet bowl flange, neoprene dish glove and drilled a hole for the nozzle to poke through the side. I use my left hand to hold the part inside the tote and right to hold the blasting gun on the outside. I also cut a hole in the lid and used a wide mouth tea bottle with a few scotch bright pads cut to fit inside and a hole in the end for air pressure to escape. the only issue is the lid need foam sealing tape and come clips to keep the media in. Coast me about $20 to make.

This thing is a piece of junk please do not buy you be throwing money away

Using it as a soda blaster, works really well

Works fine for small blasting jobs

Light and easy to maneuver around the work peace

For a cheep sandblaster this works quite well for smaller parts. Easy to control flow and the added pressure gauge is a bonus

Ive read some of the negative reviews and had no such problems with the one that was delivered to me. It works well for small areas and especially seams where you cant get any other tool into. *Carefully read the instructions and warnings.*

Qualité-pris sa va bien.Les filets de serage du cadrent de pression son lous et faible.