













TKDMR 10pcs 1/0 Awg-3/8 Ring Marine Grade Copper Wire Lugs,with 3:1 Heat Shrink Tubing,UL Battery Cable Ends,Heavy Duty Cable Lugs,Tinned Copper Eyelets,Tubular Ring Terminals
-
Lia Lockman MD
> 3 dayI figured 10 should be enough for one solar unit construction. It was JUST enough by the time I was done. I used a hammer drive crimper, and they grip well. The heat shrink makes a nice cover for the ends. I was doing overkill on the wire size, but these work on 2/0 wire, too. Good deal.
-
Angeline M.
Greater than one weekI like that they are closed ends and flared fittings. This made installing my slightly oversized 4 gauge wire much easier than some SC25-6 lugs I ordered and couldnt fit on the cable. They crimped well with a hammer crimper and the two colored heat shrink wrapbreally helped with cable ID (because both my + and - are blue). I believe I even had to drill one of them out for a larger post and it only took a few seconds and didnt destroy the lug, which is always a plus. Would recommend these over the generic metric branded lugs.
-
chris rodriguez
> 3 dayIt was nice to have the shrink tube with it
-
Dani P.
Greater than one weekGood quality connectors for a battery bank and inverter installation. You need a special crimper so dont forget that, but with the proper crimper every connection was solid and the heat shrink it comes with is of good quality.
-
Nitzan S.
> 3 dayWell working with the hydraulic crimper.
-
Jimmy Ferguson
> 3 dayThese are top of the line connectors. I use them to replace welding leads in a fab shop. Heat shrink is as described, shrinks as it should. I will use these again. A+
-
Daryl F. Vallad
Greater than one weekWorked perfectly for replacing the battery cable ends on my boat, the included heat shrink was an added bonus.
-
Sara
Greater than one weekVery good!
-
Ms. Cathryn Anderson
> 3 dayThese 1/0 connectors were exactly what I needed to to make cable connections to wire up a winch on my vehicle. I used a 10 ton hydraulic crimper with 50 mm jaws to crimp the connectors to the cable to ensure connection was solid. Heat shrink was regular heat shrink I believe it will hold up to keep out moisture as I utilized a heat gun and made sure it was well molded and heat shrink glue protruded from the ends of the tubing evenly. I would most certainly recommend these and will be purchasing again for my next project.
-
Chuck R.
> 3 dayLove it fits perfectly!