TPU Protective Silicone Case Skin Cover Shell for Playstation PS Vita 2000 PSV 2000 (Clear )

Looks good, doesn’t slip off and there aren’t any gaps. It’s just what I was looking for BUT..it doesn’t match the buttons properly. This can make the buttons a bit hard to press. The bottom leans to the left, but doesn’t affect anything. However, the top leans to the right which covers the right trigger. I had to cut part of it off to make the button usable again, so don’t mind the bad job I did at doing so (I used scissors!) If you can look past that, then I’d recommend it. Its a nice case type option to the crystal or silicone cases out there. I’d buy it again.

This is a TPU silicone protector. It covers the edges and back. It doesnt cover the buttons, screen, or touch panel. It doesnt impede the shoulder buttons at all. Also leaves access to all unobstructed. It does make operating the volume and power buttons harder, but not impossible. Over its exactly like similar protectors for phones. Covers the edges and corners from impact and doesnt block the screen or ports. It also provides a satisfying grip. Exactly what I needed and wanted. Combined with proper screen and touchpad protectors its great protection for an amazing handheld.

this cover goes on and stays on, without being too bulky or covering up the vita’s looks. it does require a little pushing and pulling to get everything lined up, as it’s slightly stretchy. I agree it’s a bit difficult to push the top buttons with the cover on.

I bought this in 2 colors because I couldnt decide on one. This case is a great low profile non bulky case and is made of soft flexible silicon which is great for shock absorbtion. I have a tempered glass screen protector on the front and a standard screen protector on the back so my Vita is fully protected even though this case doesnt fully cover the front. My Vita also fits in my travel case with no problems with this case on it!