









TRIM Cutting & Grinding Fluids SC520/1 General Purpose Semisynthetic Fluid Concentrate, 1 gal Jug
-
Brian W
> 24 hourWorks very well at a cheap price Not intended for mister system
-
Mr. Knowitall
> 24 hourI have used this in Milltronics VMC for about 8 months with no bubbler and it still has the same mild scent, almost unnoticeable. Corrosion prevention appears good. It will irritate your skin wear gloves when handling for very long.
-
Mike
> 24 hourWide range of effective concentration. Stays emulsified well with intermittent use a few weeks in between. Has almost no smell and hasn’t cause any skin issues. Protects the metal well, the mild steel filings I left on my bandsaw have little to no rust which was surprising to me.
-
oilreclaimer!
> 24 hourMixed 60 mL to 32 oz water. Working well on mild steel,aluminum and cast iron. Corrosion inhibitor works very well with no sticky residue on parts
-
Mike
> 24 hourWide range of effective concentration. Stays emulsified well with intermittent use a few weeks in between. Has almost no smell and hasn’t cause any skin issues. Protects the metal well, the mild steel filings I left on my bandsaw have little to no rust which was surprising to me.
-
Pogoda
> 24 hourI read through some of the comments on the mix ratio and settled on trying 5 oz per gallon. Ran my mill in the evening and shut down. In the morning I came into shop and the mill had started to rust. I cleaned that up and increased my concentration to about 1/3 of a gallon of Trim to 4 gallons of water. That works pretty good but I still see a little bit of tendency to rust here and there. Thus I am going to use a full half gallon of Trim to 4 gallons of water. That might be a bit heavy, but rust is no fun! I spent about 20 years in the machine shop in one career. that ended in 1994. So I have seen my fair share of coolant. I would say Trim does a nice job and is pleasant to work with vs what we used back in the day. But do watch your concentration level! P
-
Gatz
> 24 hourWorks well. No smell. Keeps lathe and mill clean
-
Greg
> 24 hourI like the ease of use, lubricity, smell and clean up. I have had no issues with this lubricant and no rust issues either.
-
Dave M. Shaw
> 24 hourIts hard to figure out mix ratio, but with enough reserch most places say 3 to 6%.. But to eliminate machine rust I go closer to10%
-
Chains956
> 24 hourHavent had a lot of time working with this coolant bu so far so good. Lubricity seem good . No rust issues yet . It maybe a problem down the road with residue. Machine is sticky after use . It calls for 1.8 binx dilution. I guessed at mixing it ( 1 gallon jug) in 3 machines with 5+gallon sumps . So at 1.8 binx i have another 6 gallons mixed . 22:1 would be a good starting point