







Tripp Lite Standard Computer Power Cord 10A,18AWG (NEMA 5-15P to Left Angle IEC-320-C13) 6-ft.(P006-006-13LA),Black
-
Ronald Stallion
Greater than one weekGreat product
-
gotJeep?
> 3 dayIts a power cord with an angled plug on the end... electrons appear to flow freely in both directions, so I think its doing the job it was built for.
-
bmac32
> 3 dayWhen moving a 24 to a different mount ran into problems with electric and cable connection. Wall mount is a simple bar of metal with 2 1/2 holes and mount on TV is 2 pegs that stick out about an inch so this places the TV very close to the wall. With this cord there is plenty of room because of the 90 degree angle as it ends up sticking out from the TV about a 1/4 inch.
-
Copper
> 3 dayThis is the only cord I found that turns this way. If you are looking for a cord that turns so you can push your device closer to the wall, make sure you get the cord that turns the right way. Almost every cord out there turns the same way. but this one turns the opposite way. It was the only one I could use for my stereo tube amplifier; thank goodness someone in the manufacturing industry thought of that!
-
Joe Liberty
> 3 dayPerfect !! Did what was needed.
-
Alec Woods
> 3 dayWorks perfectly, sits nice and flat on the back of my projector rather than leaving unsightly cables protruding everywhere.
-
user
> 3 dayi ordered this and the the Cables To Go 3152, noticing that they were different from the description pictures. i needed the lowest profile possible for my application and decided to do a side-by-side comparison. the Cables To Go was lower profile! what i got was not whats on the picture, which i guess is fine if youre just looking for a 90 degree bend. whatever reviewers might say about the metal quality of the Cables To Go one, im only powering a little 15 LCD and so i dont plan on drawing a lot of power through the cable. im going to try to upload a picture of the two next to a ruller so you can judge for yourself if it fits your application. as for me, this one is going back.
-
David
> 3 dayGood product.
-
M. C. Albury
> 3 dayJust what I needed for my Prusa 3d printer in its enclosure. Heavy duty wire.
-
Rosielab
> 3 dayReally this is the cord the printer should have come with. I love that it is flush and I dont have to worry about the cord wires fraying due to the pinched way it was before.