UniTak3D Mono X FEP Frosted Release Film,3D Printer Accessories for Mono X 4K,6K,Photon M3 Plus Elegoo Saturn,NOVA3D Whale 2,for Creality LD-006 8.9Inch UV DLP LCD Resin 3D Printer 260x180mm(5pcs)

I wish it were specifically designed for my machine (Mono X) with the holes included. I was nervous changing my first FEP because I was afraid I might make a hole too big, or cause a tear, by having to make my own holes. If the AnyCubic store had any inventory I still might buy from them because theres does have the holes.

Worked out great! Easy to use.

Calidez bueno transparencia bueno grosor bueno

Install was easy and the stretch came out great! First couple of prints I use RainX to prevent and sticking to the FEP. After that it just works as designed.

I had high hopes for this fep film!!! Unfortunately it did not work out at all! First film distorted after the first print! Second film scratched extremely easily and was garbage after the 2nd print!!! It’s a shame I got two sets of these!!! Will NOT BE USING THE SECOND SET!!! SAVE YOUR MONEY!!!

Goes in easy. All you have to do is trim the excess off with a knife once it is fully installed. No problems printing.

Great product! Fit as intended.

I’ve only ran 3 or 4 prints since swapping this in, but great first impressions. Actually seems to work better than the original film, but I don’t have any objective reasons to feel that way… likely I’ve just improved print settings / calibration.