













Upcut Spiral Flush Trim Router Bit, 1/4 Inch Shank Solid Carbide Flush Trim Router Bits Spiral with Nano Coated by EANOSIC (1/4 Shank Up-Cut)
-
S. Smith
> 24 hourI have a CNC and it has been great for cleaning up projects and especially for cutting tabs often used when not cutting all the way through on the CNC. It has not had a lot of use yet and hope it is as durable as expected! I have a couple bits from the same manufacturer with no problems at all.
-
Ryan
> 24 hourThis bit is a great value. Good quality and leaves a great finish. I like the coating.
-
Woogaloo
> 24 hourThis bit is great. I needed to trim down some of my benches at in the shop to make them flush and the bit left a smooth edge. I was very surprised at how nice the edge looked! The bearing rides really smoothly on the piece you are trying to flush trim. You could also use it for templating which I plan to soon. Even after cutting through plywood the bit still looks sharp and with the blue coating should help it wear evenly over time. Highly recommended!
-
p kerns
> 24 hourGlad i bought the two pack and had an extra template. Failed after 6 cuts. The second but did fine for this project.
-
shwakman
> 24 hourThis bit cut fantastic for about three pieces, on the fourth piece it broke. I’m disappointed and now my projects are behind. If the seller could contact me, I would appreciate that. I bought this about 8 months ago but just started using it a couple days ago.
-
Chris S.
> 24 hourNeeded an upcut/ downcut 1/4 flush trim bit, bought one each. Only used the downcut so far, but it meet my expectations
-
Bass
> 24 houri was very impressed, but only used it for one small project.
-
Nova_GTS
> 24 hourI used this to cut starboard and after probably 20+ feet of cutting seems to still be sharp and the bearing has not failed
-
Andy
> 24 hourA well made router bit. Not sure what the blue coating does but the bit holds up the job well. Tens of meters of trimming so far. Nice :) I will buy it again when the next project pops up.
-
Jeff
> 24 hourI do most of my work on the CNC, and we leave tabs to prevent the piece from flying around. I switched to this flush trim bit to remove the tabs and to clean up in the machine doesnt cut all the way through. The cut lined up with the bearing and cleaned so smoothly. I highly recommend it; this will be my shops standard bit.