Whiteside 6210 CNC Spoilboard Surfacing Router Bit, 1/4 Shank

Works great good value!

Cuts good, gets a little hot but not too bad. It cuts epoxy well.

Once I surfaced my spoilboard I was able to properly tram it. Then I surfaced again and now all my cuts are dead on flat as the should be. This is a got to item!

Ive used this bit several times to flatting a few slabs. I wanted a slightly smaller cutter so I could use my palm router and not overload it. This bit works perfect and leaves a great finish on my slabs. It took 2 passes of sanding after to get a great finish.

Bought this for surfacing my spoil board which was great. I don’t have a planer in the shop so decided to try planing some mahagony with it and that worked wonderful as well. Whiteside makes wonderful products at a great price point.

I have a Shapeoko 3XXL and needed a bit to clean up the spoil board. The Whiteside is simple to use. I emailed Whiteside support and they provided the feeds and speeds to use. I have a lot of Whiteside bits and love them all.

You just cannot go wrong with Whiteside bits. I try to use them almost exclusively.

Bought this to flatten boards to wide for my jointer and for end grain cutting boards. Works great

Bought this to flatten cutting boards and hardwood boards with a router sled and a small plunge router. Works great so far as a substitute for a planer. Leaves some tool marks, but they sand right out.

This bit did a great job leveling the spoil order on my CNC router table.