Whiteside Router Bits RD1600 Standard Spiral Bit with Down Cut Solid Carbide 1/8-Inch Cutting Diameter and 1/2-Inch Cutting Length
-
The Concrete Cowboy
> 3 dayWe use a lot of Whiteside bits. Reminder that the cut depth on these is only one inch. Typically we use 1.5 cut depth but these work great for most cuts.
-
Arlifus
> 3 dayI like this bit like my other Whiteside bits. Woodworking is only my hobby so I cant attest to the longevity/durability of the bit. I have used this bit with a small trim router mounted on a table. Ive checked the resulting cuts with my calipers and the bit cuts accurately and cleanly. The spiraling left clean surface edges and pushed the chips into the dado as I expected. I mostly made incremental passes at 1/8 depth but the few that I did at 1/4 depth looking just as clean but needed to go a little slower. I did notice that this bit was a tad bit harder to get into the collet of my router. When I checked the shaft, it appeared to be about .001 larger than the ones I compared it to. This seems to be within acceptable tolerance to me so I chocked it up to being new.
-
Hank suffoletto
> 3 dayHave no issues with this bit
-
Justin M Neu
> 3 dayObviously its only a bit, so its hard to swallow paying this much money. Time will tell if its worth it. Ive cut multiple projects with it and its performed great!
-
Ken B
> 3 dayProduct as described by seller; high quality and fully meets my expectations. I will order from this supplier in the future.
-
Ms. Lillian Dibbert
> 3 dayThis bit is a good quality bit and provides a smooth cut . I will continue to purchase Whiteside router bits due to the low cost for a quality bit .
-
Chuck
> 3 dayWould purchase again. Cuts well
-
Siggy
16-11-2024This is a pretty awesome work horse that I’ve been using for about two months now. I would definitely purchase again.
-
fahd el gatrif mizher
> 3 daytodo bien
-
Greg B.
21-11-2024Nice for the price. I have a lot of these.