Wixey Digital Angle Gauge Type 2 with Magnetic Base and Backlight

Works good no problems goes beyond 90 degree

This thing makes woodworking much easier.

Easy to use, fast response, easy to read, saensitive.

Compact, very useful

I noticed a few negative reviews but, many, many positive ones so I purchased it. The one I received is excellent! It repeats, and according to my machinist square, it is dead on accurate. Certainly within the 0.1 deg. as advertised.

I bought this for my husband as he loves this type of tool. He LOVES it!!!!

Works great for setting your table saw or miter saw to the angle you need.

Bought this for my table saw (as well other uses) and works great thus far. I first zeroed out the gauge on the table of saw and then raised blade for attachment with the included magnet. Read off to my miter gauge readings on the saw so adjusted for true square 90 degrees. Lowered blade and checked as far down as I could and held true. Cuts were great consisting of an X brace on 2, 2x4 boards at a mitered 45-degree cut. Both boards cut true and clean and interlocked great. Works great and now an invaluable tool in the arsenal for my hobby woodworking.

This Wixey WR300 digital angle gauge worked great for checking the wheel alignment on my Buick. Now I can completely align my car without taking it to a shop. Check Youtube to see how to make a cheap fixture for checking Caster and Camber and how to do a 4 wheel alignment using string,( I use fishing line) watch them all because there are only one or two that really show the correct way to proceed. This gauge is very accurate with a steady readout once you obtain the angle you are looking for, nice strong magnet too. I would say it should be great for any project you may have. I looked at a lot of them before I choose this model. Very satisfied.

I have been a trim carpenter plus contractor for 15 years. I could have saved a lot of money, saw blades, my joints from walking back and fourth, if I would have bought one of these long time ago... This is an absolute must! You zero it one one surface then put it on another surface to compare angles. Works great for squaring your saw blade to the table or finding what angle to cut stair parts or whatever. I bought this after I made 4 maple newel posts and after gluing them up they had gaps on the miters. I put it on my table saw and it was off .5 degrees which is 2 degrees added up on 4 sides...I ended up throwing the posts out after trying to save them for 2 days. I made new ones and put it on my jointer at exactly 45.1 degrees and they turned out amazing. Ill never not use one of these again.