Wolfride Rabbet Router Bit Bearings Replacement Bearings for Router Bits | Inner Dia. 3/16” & Outer Dia. 3/8, 1/2, 5/8, 3/4, 7/8, 1, 1-1/8

Saved several bits. Had them sharpened and with new bearings better than new.

Buy it if you need it. Worked well for me.

Nice to have when needed

Used bearings in the construction of mower blade balancer. Worked well for the project.

Alert - The heading is misleading. The Bearing ID is not 1/4 - its .2 inches BLECK

What a waste of money. These WILL NOT fit a 1/4” shank bit. They are too small. You cannot make them fit. Not sure what they are supposed to be used for.

first use I failed to provide a backer board when routing a small rabbet in a thin piece of plywood and the bit gauged too deep when the bearing flexed slightly... MY BAD!!! great selection of sizes, lots of attachment screws, good accessory for my router

First bearing self destructed in less than 5 minutes. Installed an OEM, its working fine. Have not tried the others.

Saw this on a You Tube Vid being used as a mower blade balancer and glad I did. I mounted it on a 2x4 at one end of the shelving in my basement. Drilled a level 1/4 hole a little over an inch deep and pushed the shank in the hole. Tried it out today and it worked great !

Put the first bearing on a router bit, turned the router over and the seal fell out. Put on a 2nd bearing and this time the seal fell out after I turned the router on. Didnt even get to try them in action.