

XiKe 4 Pcs 22333TB (10-10) ID 2.250 x OD 3.376 Trailer Hub Wheel Grease Seals, Fits 5,200, 6,000 and 7,000 lbs Axles/Spindles D42.
-
AmznAtomic724
> 24 hourgood tight fit. no leaks after a few hundred miles on the trailer
-
Donald
> 24 hourInstalled the grease seals. Perfect fit - rubber seal was nice and tight on the spindle.
-
Rebecca Munn
> 24 hour1.5 inch inside diameter, 1.98 inch outside diameter. Arrived quickly, fit perfectly, low price and job done. I love Amazon Prime!
-
Daniel Cross
> 24 hourWorked perfectly for my trailer. Do yourself a favor and buy a new set every time you re-pack your bearings. Id buy again if necessary.
-
Ross Robinson
> 24 hourParts showed up quickly and were as described. Fit my Dexter hubs perfectly
-
Claxton10
> 24 hourRepacked the bearings on my featherlite cargo trailer and these fit perfectly. Local parts store wanted 3x the price.
-
David Christensen
> 24 hourThis fit well and so far are holding up OK
-
Jay Rutherford
> 24 hourIf you want to remove your inner wheel bearing to clean it and regrease it, you have to pry out this seal. Doing so destroys the integrity of the seal, so you always need to use a new seal. These are easy to install with a block of wood and hammer after servicing the inner bearing. Work great.
-
Rob
> 24 hourHub/bearing kit I bought had different ID seals than I needed, so these did the trick. Have not had any issues with them. They were properly sized and seem to be of decent quality. One caveat is that unlike the seals in the kit, these do not have a very deep dish to the steel cup part, so its easy to drive them in too far, but they work fine if installed with some care.
-
Huna
> 24 hourThese worked great for my boat trailer axels. Went in just fine.