2/0 AWG 2/0 Gauge Red + Black Pure Copper Battery Inverter Cables Solar, RV, Car, Boat 2 feet 3/8 Cable Lugs
-
Mike
> 3 dayVery good value.
-
Frank
Greater than one weekWell made and look good too. They work perfectly for running my 12v deep cycle batteries in parallel on my RV. Very happy.
-
Bookoo
> 3 dayLength is measured tip to tip, not center of lug hole to lug hole. Keep that in mind when ordering.
-
T. Griffin
> 3 dayBut its really nice wire. Very well made battery connector wire with solid lugs. Surpassed my expectations for quality and value. Id buy again.
-
G. Or J. Horn added
> 3 dayVERY well made with solid terminals, properly crimped. However please note that your battery terminals MAY be 3/8” ...not 5/16”. (I drilled these out to fit my boat and discovered they are solid tinned-copper as claimed.). Nice product, very flexible due to fine/small wire-construction to make this heavy duty cable.
-
LeRoy D.
Greater than one weekWorks great in my solar system.
-
zarxs
> 3 dayWhen I upgraded my inverter in my backup power system to a 1200 watt pure sine model I wanted to avoid the problem I had with my old cables (old ones were too small and used allegator clips). These new cables are way overkill for my use but the inverter is very very happy now.
-
Kona256
> 3 dayThe cables are a good quality and have nice ends. They are sturdy and should hold up well.
-
Eric
Greater than one weekUsed in a 68 Ford Bronco for battery cables. They look good and work as they should.
-
Rick Tara
> 3 dayGood solid connections
Power-Flex Battery Cable
WindyNation"s Power-Flex welding battery cable is a highly flexible industrial-grade electrical cable manufactured to the highest standards right here in the USA! A high strand cable count combined with a soft, pliable EPDM insulation results in a flexible cable every time. Our cable is resistant to tears, cuts, abrasion, water moisture, and oil-based solvents.
Polyolefin Heat Shrink Tubing
- 2:1 shrink ratio
- 600V rating
- Operating temperature: -55C to 125C
- Resistant to many solvents including salt water, gasoline, diesel, grease, etc.
- Manufactured by WindyNation Inc
Pure Copper Tin Coated Cable Lugs
Heavy Duty
WindyNation"s pure copper tin-coated cable lugs are heavy-duty, pure copper, and are ideal for marine and humid environments because the tin coating protects the copper cable lug from corrosion and oxidation. If you need cable lugs for an outdoor installation on your RV, boat, car, truck, golf cart, off-grid wind, or solar installation, then WindyNation"s tinned lugs are your go-to choice!
|
|
|
|
|---|---|---|
SpliceCables are precisely cut and stripped on automated robotic cable processing machines. |
CrimpCable lugs are attached using a 6-ton pneumatic crimper with custom dies, resulting in an ultra-strong, non-removable crimp. |
InsulateAfter crimping, polyolefin heat shrink tubing is applied to eliminate the possibility of moisture or chemicals penetrating into the lug/cable interface. |
Made In The USA
WindyNation is one of the nation’s largest manufacturers of assembled inverter cables in the USA. We manufacture hundreds of thousands of inverter cables every year at our headquarters in Ventura, CA.