2/0 AWG 2/0 Gauge Red + Black Pure Copper Battery Inverter Cables Solar, RV, Car, Boat 2 feet 3/8 Cable Lugs
-
John
Greater than one weekThese were exactly what I needed to hook up my battery to and inverter for a solar panel hook up.
-
Kindle Customer
> 3 dayworks fine for my small solar system.......
-
Michael
> 3 dayUsed these cables to make a quick connect set up for an electrical inverter.
-
orker PA
> 3 daygreat product AAAa
-
Douglas Rowland
> 3 dayUse for powering an 1kw inverter. While 4 gauge cable would had been fine, always better to go one size more than required. Was not that much more than 4 cables.
-
Tom & Emily
> 3 dayI expected these cables to be more over promised junk. These are very heavy cables with great quality ends and the proper amount of insulation. Several times in the past I have purchased cables that appeared to be exactly as they were represented, upon further investigation I realized that they were 10 gauge wire with super thick insulation to make them look heavy duty. That is not these cables. These are good quality and appear as if they will last me quite a while.
-
Bookoo
> 3 dayLength is measured tip to tip, not center of lug hole to lug hole. Keep that in mind when ordering.
-
Nicholas
Greater than one weekExcellent bought a few more once they came in. No other wire as flexabile and exceptional quality like this
-
lance powell
> 3 dayHad no problems bending them to Half Moon shapes to attach to solar panel batteries just install them they seem to be helping with current flow
-
Harun Kasera Adongo
> 3 dayUsed to contact with 2000 inverter. After a short while, the black cable burns/heats up quickly. You see fumes/smoke coming at the the cable/inverter connection when you put a load like a 700W microwave for over a minute. Power will likely cut off at that time. Happened even for running a small fridge. I had to replace it with a 3ft 2/0 cable from Harbor freight (up to 5000 W). This has been working great. Can now run same devices as needed, and the black cable doesnt show any sign of warmth.
Power-Flex Battery Cable
WindyNation"s Power-Flex welding battery cable is a highly flexible industrial-grade electrical cable manufactured to the highest standards right here in the USA! A high strand cable count combined with a soft, pliable EPDM insulation results in a flexible cable every time. Our cable is resistant to tears, cuts, abrasion, water moisture, and oil-based solvents.
Polyolefin Heat Shrink Tubing
- 2:1 shrink ratio
- 600V rating
- Operating temperature: -55C to 125C
- Resistant to many solvents including salt water, gasoline, diesel, grease, etc.
- Manufactured by WindyNation Inc
Pure Copper Tin Coated Cable Lugs
Heavy Duty
WindyNation"s pure copper tin-coated cable lugs are heavy-duty, pure copper, and are ideal for marine and humid environments because the tin coating protects the copper cable lug from corrosion and oxidation. If you need cable lugs for an outdoor installation on your RV, boat, car, truck, golf cart, off-grid wind, or solar installation, then WindyNation"s tinned lugs are your go-to choice!
|
|
|
|
|---|---|---|
SpliceCables are precisely cut and stripped on automated robotic cable processing machines. |
CrimpCable lugs are attached using a 6-ton pneumatic crimper with custom dies, resulting in an ultra-strong, non-removable crimp. |
InsulateAfter crimping, polyolefin heat shrink tubing is applied to eliminate the possibility of moisture or chemicals penetrating into the lug/cable interface. |
Made In The USA
WindyNation is one of the nation’s largest manufacturers of assembled inverter cables in the USA. We manufacture hundreds of thousands of inverter cables every year at our headquarters in Ventura, CA.