3D Printer Heatsink Kit + Thermal Conductive Adhesive Tape, Cooler Heat Sink Cooling TMC2130 TMC2100 A4988 DRV8825 TMC2208 Stepper Motor Driver Module (22pcs)

Great heat sinks for my duet wifi 2 board. They fit perfect. They will also work for other drivers and other applications. Comes with double side tape on the one side. It holds very strong.

I have no idea how well the adhesive transfers heat, but nothing has burnt up. They stayed stuck.

fits well and stays on my driver ICs. keeps them cool.

I used these as heatsinks for the VRMs on my old motherboard. First, I super-glued them in pairs, and then stuck them down using the attached adhesive pads. Simple and effective.

Used these to hopefully help my Roku Streaming Stick run cooler. I tried to use a little HDMI extension cable, but that didn’t work. So I cut a small rectangular hole in the case and stuck three of these to one of the big metal bits inside. Should help everything run a little cooler. Adhesion seems acceptable. UPDATE: seven months later, I haven’t gotten the overheating message once and the heat sinks have stayed in place! Cheap fix for a really annoying problem!

I purchased these little heat sinks for the vrms on my mobo as it was not equipped. When I saw they were available in blue I snapped them up because most on my case accented were blue too. They work very well according to temperature sensors display. Nothing worse than having a burnt out vrm and choke to ruin a good motherboard.

Just peel off the adhesive and attach. Seem to work well. Especially when used on various 3-pin voltage regulator chips.

Did exactly what I needed

They work as they should, they adhere really well. Will buy again.

Did there job. Let me make my Ender 5 Plus a true dual Z-Axis printer.