













4 Packs 5 inch 8 Hole Hook and Loop Replacement Sanding Pad for DeWalt DWE64233 & N329079 Compatible with DWE6423/6423K, DWE6421/6421K, DWE6421-B2, DWE6421-B3, DWE6421-BR, DCW210B (4 Packs)
-
Simon Badeaux
> 24 hourFit dewalt sander perfect. Make sure your sander has 4 screws and not 3.
-
Jodys Jewels
> 24 hourIt is a great product and easy to install
-
megan hege
> 24 hourThese are trash. Lasted less than 5 minutes as the plastic where the screws go melted. Waste of money and dangerous how it heats up and melts.
-
P. Hunsicker
> 24 hourThe center area that goes over the cam on the sander is so soft that when you tighten it down to the sander you end up with a bubble and not a flat sanding surface. Product was a dissappointment for my sander but repurposed them as small hand sanders
-
Sue
> 24 hourThe 2 pack replacement pads came quickly, and were priced competitively. Easy to swap over and perfect fit.
-
Suzanne M. Lawson
> 24 hourI wrote a letter of complaint shortly after receiving and using one of these replacements on my Dewalt! It worked fine for about a half an hour and it started vibrating excessively. Not thinking too much about it because the sanding discs were wearing out after about five minutes of moderate use. The next thing I knew the sanding pad had broken off at the screws and flew across my work area and melted my mount on the fairly new Dewalt orbital variable speed sander. I consider this as a dangerous replacement and now I have to buy another sander! I have not received any reply from amazon about my complaint! I have never complained about my prior purchases but this is ridiculous!!
-
Spencer Williams
> 24 hourquick service, good products
-
royltt
> 24 hourInstallation is very easy, and they hold the sandpaper firm. I am very satisfied with this product.
-
Richard Snyder
> 24 hourFast delivery and works great
-
Mason Shanahan
> 24 hourThese discs have a plastic backing instead of a metal heat shield. The sander heats up due to friction while sanding and the plastic backing melts allowing the screws to pull through the holes and the whole velcro disc goes flying off while in use (not just the sanding disc). I thought the 1st one was just a fluke so I installed a new one with the same results. I am returning these and purchasing some with a metal back. These are junk and dangerous.