5 Inch 8 Hole Hook and Loop Replacement Sander Pad for Craftsman 315112170, 315116940, 315116950, 315112180, 315279870 Random Orbit Sanders

Great value - the lowest price I found with the hole spacing I needed. Better adhesion than the original pad on my sander.

These fit perfectly on my Craftsman sander. However, the “hook-and-latch” engineer missed the mark on design. The profile is slick plastic, and a standard sanding pad will last a few seconds and then fly off. I’ve been using palm sanders for decades, and am thoroughly disappointed in these.

Purchased to replace the pad on my hyper tough orbital sander. The holes didn’t line up. Had to drill the into an oval to fit. And had to drill four extra holes to mount on orbital. Once installed it worked as it should.

This is a poor substitute for a Craftsman part. It broke the third time I used it with light use only. The plastic ring where the screws anchor it to the sander all sheared. I would not recommend this product.

When I loaned my sander to a friend the old pad came off. This replacement was easy. My friend has sanded some table tops with it.

This fixed my sander very well. So much better than buying a new one. Like new.

this was easy to install. Just remove 4 screws to take off the old pad and use them to add this more substantial one. The hook and loop works perfectly with the disks I bought. There is one caveat for using this with my B&D BDERO 100. The original pad is glued to a backing plate that fits into a collar. This product does not have the proper profile to slide into the collar. So you have to pry the backing plate off the old pad and use it as a shim when installing this one. Took about 5 min with a chisel to get it off.

lasted 2 minuted

Installed easily. I was afraid my old sander was a goner when the pad came apart trying to remove a disk. This made it good as new. Unable to find it locally.

Cheap