5PCS FEP Film 200x140x0.15mm for ANYCUBIC Photon, Photon S, ELEGOO Mars 2 Pro, Mars 3, Mars 3 Pro, Phrozen Sonic Mini 4K, Creality Halot-one, LD-002H LCD 3D Printer

Used it for my AnyCubic zero. Did the trick. Had to watch a youtube video in french to figure it out, but it worked once I did.

Product came in large sheets. 5 pieces. Large enough that I can make 10 FEPs for my photon zero. They release great and print reliably.

These start sticking after about 10 prints. First one I wrote off as a fluke. Then the second, then the third one also started to stick right in line after about a dozen prints. Threw the rest away and got a better quality FEP. Hint, if they sell the sheets in multi-packs they are probably garbage.

Seller worked with me to issue a refund. Thank you! This shows up in search as compatible with mono 4k but in the description they state it is NOT compatible with their frames. Seller is revising their description so that it doesn’t show in searches for mono 4k.

Used for an older Photon S model and worked perfectly, only real gripe would be it picks up dust really easily and doesnt outline removing the film from the sheet prior to installation. Came perfect without scuffs and scrapes which cant be said about most FEP sheets on here. Definitely the best FEP sheets Ive used in some time, has all the normal problems (scuffs easily), but with practice youll get used to clean and safe installation. No stretching necessary, fits perfectly with some wiggle room, highly recommend!

There is a short video on how to replace these for my printer (AnyCubic Photon). A lot of screws but in the end it was very simple and took no more than 5 minutes. Clean everything off first and make sure you have a bottle cap from a soda or water, place it under the film as youre replacing it to create the tension on the first set of screws. Remove it when re-attaching to the VAT and it goes on nice and tight. Use a razor or x-acto knife around the inside edge to easily remove the excess and youre good to go. I tested a print almost immediately after that was an issue, I just re-zeroed the printer since it was slightly off and voila, back to perfect prints!

Happy so far - good option for Photon printers. No instruction so take note there is protective film on both sides of each sheet. Didn’t realize the first time I replaced until after I tightened the last bolt and ended up doing it all over again. Newbie mistake.

Ive been printing for months with no issue with the orignal FEP that came with my printer. Needed to replace the FEP, thought this would be great at half the price. Tried 4 prints. Reduced lift speed to a crawl in my settings, still failed supports. I can hear the resin sticking to the FEP (louder than normal). It just doesnt pull away correctly from whatever verison of the material is being used in this product. Will not recommend or use again.

Watch some youtube videos before you install these, but once it theyre on it allowed me to print as well as the one that came factory installed.

Cheap, easy to install, multiple sheets, it works