













6061 T6 Aluminium Metal Sheet 12 x 12 x 1/8 Inch Flat Plain Plate Panel Aluminum Sheet Plate Finely Polished and Deburred
-
Grant Gann
> 24 hour11.875”x11.875” at biggest measurements. Had to remove about 1/16th of the larger side to square the piece.
-
G floe
> 24 hourFlat sheet
-
Pete Johnson
> 24 hourGood clean sheet, perfect.
-
67 mustang
> 24 hourPurchase to use as a mounting plate for a top box on my Hawk 250 dual sport. Cheap and economical project to secure an Apache case from Harbor Freight.
-
Mark B
> 24 hourThese plates are nice except for the fact they have not been de-burred . There is about a 1-2mm burr on both sides that are razor sharp. Be prepared to de-burr this plates before use as to not cut yourself. Also the player are not 12” x 12” but actually 11.875” x 11.875” so hopefully you do not need exact 12” square.
-
Paul C.
> 24 hourI have a high precision mini-mill. Most of the time I use a high precision vise as a work holding device so I dont use the T Slots in the table ad like to keep the chips and coolant from accumulating down in the T Slot grooves and on the way covers to save clean up time between jobs as well as wear and tear on the machine and operator. With this in mind I designed and built the table covers and the back board you see in the photos. Its all bolted together with SST fasteners (mostly 8-32 and 10-32) and I used 1/8 aluminum plate. It comes protected with a very heavy plastic cover adhered to both sides which I left on throughout the layout and machining process to protect the surface finish from scratches while in process. I did all of the machining, edge polishing & beveling, etc. and the surface protecting layer stayed on beautifully until I was ready to peel it off. There was no adhesive residue after removal. How do you like it?
-
Dr. Mike
> 24 hourThis is a nice, thick, flat sheet of aluminum. My parrot chews things, and when she chews on towels on my bed when I watch TV, she can (and has) chewed right through to the bedcover. This piece of aluminum below her towel was just the thing I needed. I just smoothed the edges a little bit and rounded the corners.
-
Harrison
> 24 hourIt comes with protective layers of plastic on both sides, which is appreciated. The machine edge is straight but has lines on the edge from how it was cut, which I dont mind but some may.
-
David MacLean
> 24 hourNice smooth sheets perfect for pressing comic book magazines!
-
Thomas M.
> 24 hourIts about 11 7/8 on a side, thats OK for me but if you need exactly 12 by 12 you might have a problem.