Accessory for iRobot Roomba 600 610 620 630 645 650 655 660 680 500 Series Model 595 Replacement Kit Replenishment iRobot Parts Set Filter Side Brush Bristle Brush Flexible Brush

The 2 big roller brushes and filter work and fit perfect with my Roomba 600 series. But the yellow front right side spin brush doesn’t fit. The opening where you put the screw in isnt big enough. The screw flat head doesn’t sit down in it to make it a snug fit and you can’t screw the screw down properly. It just falls off. I tried using a exact-o knife to scrape away some of it to make the opening larger for the flat head of the screw to sit in and it’s eh’ it doesn’t spin. Everything else worked fine though. Saved me $50 ish buying this kit from Amazon instead of buying from buying the replacement kit from Lowe’s.

Screw would not tighten up. Brush would fall off. The old screw would not fit the new brush. That’s the yellow brush that goes in the front.

Everything in this kit installed easily and now my roomba is as good as new.

I have a Roomba 690 that I bought in 2019. The side bristle kept coming off along with the screw and I got tired of looking for it. I found this pack with 4 new side brush/bristle thing along with the needed screws plus all the extra stuff that I’ve never replaced (except the filter once). Everything fit perfectly! iRobot wanted $14.99 for just for 3 of the little side bristles! BUY THIS!

Funciono perfecto

As the title suggests these are just as good as the OEM Roomba parts, at a fraction of the cost.

Fit my roomba perfect

Was in desperate need of replacement accessories, after too many hours of usage on our old ones. Found these, and they shipped quickly and were relatively cheap. Easy to install and our roomba is back to cleaning up even more.

These are much cheaper than the ones from the company but my vacuum will go for about 10 minutes before it stops and prompts me to clean the brushes

I was really looking forward to these replacement parts, they all fit in my room by 620 just fine except for the rubbery roller, I cannot get the square end of that to go back in the opening. The old one goes in and out fine, the new one seems like it is a little too big. Anybody else have this problem?