Amana Tool 45624-K SC Spektra Extreme Tool Life Coated V-Groove 60 Deg x 1/4 D x 31/64 CH x 1/4 Inch SHK 3-Flute Router Bit

I used this bit to do inlay. It’s very sharp and cuts awesome

Cuts so clean there is barely any extra cleanout.

I like this bit alot. works well and cant complain

This is in Maple 0.100 deep, was hoping with 3 flutes it would carve better, tried different speeds and feeds same results. Tried to find someone to contact at Amana Tool, sent email to them no reply yet.

Great bit for . 5-2 text engraving.

Ive been using it for a few months already and its just such as good quality bit. My carvings started to look better, much better. And I ended up using this one more than my favorite 90° bit (although theyre from China and cant be compared with that masterpiece).

Ok, first time using one of these. I made a few test cuts on oak with lettering. they were small letters and it worked great. So I decided to try some bigger cuts and it had no problem cutting 1/4 in deep in a single pass with no burning of the wood or chatter. I was cutting at 400mm a min and it worked great

It chipped a very small corner when carving foam on my avidcnc. I did an easy pattern through soft wood and you can see what happened to the bit. Maybe I got a bad bit but it appears like they are not durable or long lasting. Buyer beware. Will buy a second to test again.