Authentic Capricorn Bowden PTFE Tubing XS Series 1M for 1.75mm Filament with PTFE Teflon Tube Cutter, 2X PC4-M6 Extruder Fitting, 2X PC4-M10 Hotend Fitting for Ender 3 V2/3/3 Pro/CR-10 3D Printers

installed it on my Sunlu S8, and my CR-10, a worthwhile upgrade, filament slides thru with near 0 freeplay in the tube and does way better with retracting

On time and as Described

Great product! Way better than stock tubing.

did the job for 6 prints, and thats about it

I have had to switch back to my old tubing. This internal diameter is too small. It was unable to push the filament through properly and caused my prints to turn out bad. I could feel the resistance when I tried to push the filament through by hand. Once I switched back, prints came out good again.

Just get it, you know you need it and it’s worth it. Stop reading and get it!!

Couldn’t print at all using this tubing. It was too narrow and difficult to even manually push filament through.

Works great! Fit well on my ender 3v2! Feels higher

Just purchased and Ender 5 Plus and the existing filament tubing is lacking. As a 3D Printer, standard tubing lacks the heat tolerance that a Capricorn tube can handle and inevitably will fail and cause you grief. Packing was great with 3 feet of tubing, a cutter to flush cut your tubing which is important that the end of perfectly flat when inserted into the hot end. There were also two connectors if you need them as well as some flair (Cool Capricorn sticker). All in all a great purchase and insurance if you own a 3D Printer.

Perfect fit and great quality.