Double Sided Tape, Heavy Duty Mounting Tape Clear, Vhb Waterproof Foam Tape,Special for Automobiles,for Autos, House & Office Decorations(1/4 in x 15.6ft), Made of 3M Tape

(0 Reviews)

Price
$7.99

Size
Quantity
(30000 available )

Total Price
Share
32 Ratings
21
4
1
3
3
Reviews
  • Todd

    > 24 hour

    I swear buy the 3M tape. This stuff works awesome and is excellent adhesive.

  • Roger B Bracken

    > 24 hour

    I used this tape to attach my front spoiler lip and it really holds tight. I HIGHLY recommend this product!!

  • Bill A.

    > 24 hour

    Used this to put a plastic accent strip back onto our travel trailers trim that the factory glue failed on. This tape has held up through a south Texas Summer in a RV that bakes in the sun. Factory glue didnt last two months of cool Fall weather.

  • randall glass

    > 24 hour

    I was helping a friend install some aftermarket body panels on his BMW. This was much better than what came with the pieces

  • Tom A.

    > 24 hour

    Used to replace tape on window deflector

  • Frieda Dooley

    > 24 hour

    I use this product for everything, recently to hang a Screenbar Plus in the underside of my above desk cabinet to light up my desk better.

  • GK

    > 24 hour

    This is NOT a VHB foam tape as titled. It is gel based snot-like adhesive which is why there are so many complaints in the reviews about the roll sticking to the packaging that it came in. Because it is a snot gel material where any form of heat or pressure makes it squish out beyond its usual protective liner pieces and thus grabs on to packaging, surfaces, and even itself, creating a frustrating mess to use. The roll also looked suspiciously light and small for what is supposed to be 15.6ft of material. So I measured. 12 feet 2 inches of tape existed on this roll. That is over 20% LESS than what was advertised and what I paid for. Will be returning and never revisiting this product or SANKA brand again.

  • Eric of Oregon

    > 24 hour

    This tape works well with Palram polycarbonate roof panels Easy to apply; just wipe the surface of any loose debris and dust, roll along the surface and cut with average utility shears; pull off red protective top layer once you are ready for the next sheet. Gives good adhesion between layers and doesn’t seem affected by temperature swing or moisture.

  • Beta8251

    > 24 hour

    This tape worked as advertised!!!

  • Product review guy

    > 24 hour

    Bought it to apply on after market rear bumper kit. I cleaned the area and applied the tape. I applied little heat too and put pressure for 45-60 minutes. After a day it came off. I wont be buying this product anymore

Instructions:
1. Before using the tape, please clean the adhesive part, keep the adhesive surface dry, and avoid dust, oil stains, moisture, etc.
2. After tearing off the release paper, paste and press, stick the double-sided adhesive on the article and press back and forth. If there are bubbles, please press with your fingers to remove them.
3,When sticking with double-sided adhesive, apply force uniformly from one end to the other to reduce the appearance of bubbles.
4. Tear off the release paper, insert a needle or knife between the glue and the release paper, pry open a small hole, and then tear off the red release paper.
5. Wait for it to be firm, press hard after pasting the adhesive, and then bear the weight after 72 hours.

NOTE:
1. The double-sided tape is opposite to the stationery double-sided tape. The adhesive is not very strong when it is just pasted, so it is convenient for everyone to modify it when the wrong position is posted.
2. The tape will work best when it is pasted for 72 hours. Don"t bear weight during this time.
3. The temperature in winter is low, if it feels not very sticky, it is recommended to use a hair dryer to heat it up.
4. Can not be used on litchi pattern surface, peeling, rough surface, or silicone material.

Related products

Shop
( 862 Reviews )
Top Selling Products