



Drill America DWTT1/2-13 1/2-13 Carbon Steel Taper Tap (Pack of 1), DWT Series, Uncoated (Bright)
-
Jonathan Allen
> 3 dayI’m not sure how long it will last but I don’t use taps very often and it served the purpose I needed it for
-
Brenda Frankhouser
> 3 dayWorks great for the price
-
tool*guy
> 3 dayThis is a taper tap which easily advances in a prepared hole of correct size or for use in chasing damaged threads. Good value for the money.
-
michla
> 3 dayJan2023: a performer for the price point, cuts cleanly with properly ground/dressed flute edges. Nickel-alloy content similar to more expensive taps thus easier to get started in steel.. At least the ones i received this order werent like the poorly manufactured threads you see too often.
-
Janette Cherba
> 3 dayI used this to chase threads in blind holes in an automotive cast iron housing prior to reassembly. It did the job I needed and after waiting for more than two weeks for the local hardware to obtain one of these taps, I had this one through amazon to use in two days for slightly less cost.
-
Rich W
> 3 dayThis tap worked great cleaning-up the treads on my old car rivnuts.
-
Dan Powsa
> 3 dayI bought the set for a one-time use of this odd size (M13x1.5). Price was right at about 1/3 the cost of other taps but the steel isnt top quality. The worked well to cut the threads I needed in cast 6061 aluminum. They came out clean, sharp and accurate but I dont think the taps will hold up for the long haul. Theyre a very good value for limited use. If you need to cut a lot of threads or plan to keep them for years, youd be better off spending more and getting better quality tools.
-
Panfilov_Dmitri
> 3 daygood!
-
Hugh Lee Helmly IV
> 3 dayrare size tap, did what i needed it to
-
Sean Eaton
> 3 dayWorked as advertised. Easy and did a great job.