Foredom 44T Handpiece Foredom Flexible Shaft Grinders - H.44T

Its amazing everything you would expect from freedom you definitely get what you pay for

This sturdy little work horse has been put through hell and back. Its cut and carved hundreds of hours and Ive yet to have a single problem with it. Burned up through an entire tx serries motor and its still as good as new.

i bought this as an Add on to the Harbor Freight Flexable Shaft I own and am extreamely pleased with. It fits perfect and works exactaly as the Original Foredon for 50.00 instaed of 300.00. All foredom hand peices work same all GREAT.

Last one lasted 10 years, hope this one lasts as long.

Arrived quickly, works as advertised

I have a Foredom flex shaft unit and I bought two extra of these handpieces so I can easily switch between multiple tools while carving - WAY better than having to loosen, remove, pick, place, tighten a bit every time I need to change up what I am doing, especially since I am often using multiple bits with different collet/shaft diameters - makes work way more efficient to have three handpieces set up for a variety of bits. These handpieces are very well made, lightweight and reasonably ergonomic (could be better but WAY nicer than using a fat Dremel tool)

Very disappointing. The runout is far worse than other handpieces I have used, creating excessively chattered cuts. I tried multiple carbide burs known to be straight and true but had the same issue with all three collet sizes. I was expecting better precision/tolerances from foredom. The tool seems sturdy and well built but does not perform where it counts. I discovered Foredom only publishes tolerances for the H.25 handpiece but of course is significantly more $. All Foredom handpieces are made to industrial standards – H.25 has even tighter tolerances. Run-out is 0.003″ measured 3/4″ out from end of chuck or collet.

I got this handpiece to be able to use 1/4 shafted accessories, and it hasnt disappointed.

Nice tool!

I had used a friends Foredom with this hand piece. He has gotten many years of services from.it and it is still working like day one. The size and ease of use make this a must have for flexible shaft carvers. it is smooth enough for fine detail but put in a carbide tip and it hogs the wood off making removing large amounts of material easy and quick.