





















Gigabit Multi-Mode LC Fiber to Ethernet Media Converter with A SFP SX Module, 1.25G Fiber to Copper RJ45 Media Converter, 1000Base-SX to 10/100/1000Base-TX, MMF, Transmission up to 550 meters/1804 ft
-
Pat Spencer
> 3 dayI use these from time to time with inexpensive switches for POE cameras with fiber interconnecting buildings… Saves you from the problems with lightning…
-
Superbolt
> 3 dayNot much else I can say but that it works great. I have an array of these going to an aggregate switch in my network and so far so good.
-
Victor H.
> 3 dayWont connect at 300 feet
-
Anthony Osuji
> 3 dayStill working for me
-
moviefan
> 3 dayDevices worked out of the box with no setup required.
-
F. S. Wolfe-Johnson
> 3 dayI was looking for something to be an air gap between my radio tower where I get my Internet from and my home servers. I simple connected a fiber line between the two and plugged in the ethernet and plugged it in, and it just worked. I have not needed to even think about it once since I installed them which I think is the whole point of this type of device. You should not even know it is there if it is doing its job and this fills that roll 100%.
-
Dave
08-06-2025Awesome, worked GREAT!
-
Freddy Álvarez
> 3 dayWorks perfectly
-
Wayne R & Andreea Boeck
> 3 dayIt works to convert fiber to ethernet. I ran a fiber cable in a pvc conduit to my backyard observatory. I used one media converter on each side. It was working even at 18 degrees Fahrenheit. The specifications say 32 degrees. It works for me.