













Homydom Wood Organizer and Lumber Storage Metal Rack with 3-Level Wall Mount, 2 Pack
-
RDSvk
> 24 hourNothing fancy, but easy to install, took longer to find studs than it did to install them. Only annoyance is the plastic end caps pop off, but they could always be glued if it mattered.
-
DC 30518
> 24 hourSimple and easy install. Very strong and sturdy. Not a single issue. The orange support legs are 3 longer than a set I bought years ago and are on another wall in my shop. I would buy these again.
-
Scott Akam
> 24 hourOverall this would have been very good if not for some quality control issues. 1. The holes in several of the pins were not drilled all the way through. 2. One of the arm brackets was not welded on straight and could not be installed. I was able to drill the pins pretty easily with a drill press. The crooked bracket on one of the arms was a bigger problem. I could not even get the pin through the hole. I used a rat tail file to open up the holes until I was able to get the pin in and the arm was sitting straight. I had to open up the holes a bit on another arm also because it was sitting a bit high relative to the other arms. It is critical to have the arms line up across all 4 racks if you dont want to have warped boards. In the end, I was able to make it work but I had to put in extra work to make it useable.
-
ColeSLC
> 24 hourEasy installation, with the simple included instructions and most of the hardware. Plenty of hardware for mounting to wood studs is provided, but for this masonry install, I (following Tapcon guidance) predrilled the blocks, then used 1/4x2-3/4 Tapcon concrete anchors. The longest part of the installation was moving and organizing my lumber to the rack. The rack had been loaded with over a hundred pounds of lumber and siding for over a week and has not budged. I now have a happy spouse with wood safely stored out of the way.
-
Jon S
> 24 hourI bought this product with a different use in mind. I was looking to get all the kids’ hoverboards and charging cables off of the garage floor as it was a hazard! I saw these lumber racks and thought I would give it a try. They are very sturdy, which is something I needed for the weight of the hoverboards. They were super easy to install, just make sure to drill into the studs for max support. I found I can fit 2 hoverboards per shelf as the depth allowed this. Easily could hold more weight than these, but this is plenty for what I needed. I am super happy with the result, and now have a clean floor and the kids do a great job plugging everything back in when complete so their toys are actually ready to be used next time they go outside.
-
larry
> 24 hourOnly had these maybe a couple of months but they holding up a lot of lumber. As others have mentioned, use heavier lag screws; not the screws included with these
-
blue
> 24 hourIt was reasonably fast and easy to install these in my storage shed. Filled in with Lumber, no fuss. They work very well. Id buy them again.
-
RiViT13
> 24 hourVery sturdy, freed up alot of space in garage. I just wish they came with a rod or strap to go between the arms up and down to secure items so the do not tumble/fall off end. In my photos you can see paracord that I tied between the arms. Thanks for helping me get my floor space back.
-
James S.
> 24 hourI got three 2-packs and installed three across and 8 foot long wall, set into wall studs and have (so far) loaded two levels with 8 foot timbers, 6 8/4 teak and 5 8/4 syp. Swallows up that load with no sign of any strain. Got more to load tomorrow. Installation was easy, relatively quick and - with care not to miss any studs - very solid. Two people made leveling the tops of each set easy using a straight edge and level to alignment. Cant find anything to complain about. Like my dad always said: If you aint got time to do it right, where you gonna find the time to do it over? This product has been done right.
-
M. Adams
> 24 hourI like these, despite some of the reviews, they arrived and assembled easily and were straight and in line. The trick is to NOT insert the holding screws on the arms all the way. I screwed them in 3/4 of the way and the arms were fine. I loaded every shelf up to its maximum because I have a lot of wood. They have been on my garage wall for over a month without issue and it has made finding the wood I need for a project much easier. I didnt use the wall screws provided however due to reviews. I used high quality SPAX 3 screws directly into my studs.