HOUSE TUNING Bar Clamps 2.25 inch -Pack 2, 2 1/4 inch Roll Bar Clamp Bracket,Led Light Mount Clamp,Roll Bar Mounting Brackets,Tube Light Mount for Light Bar (2.25 Clamp - Pack 2)

Bought these to mount front turn signals on a 2002 Honda Shadow (VT 750 ACE). Im moving and had to get the bike street legal asap and went after the cheapest thing I could get in the shortest amount of time. I was initially leery given some of the reviews of the screws stripping out while mounting, but I personally had no problems. I took it easy and stressed both screws on each clamp equally while mounting and no problems with fully seating them. The only reason I didnt give them 5 stars is because these things are CHUNKY. Like majorly so. They could easily lose 1/4 of their mass and likely still be able to stand up to off road use. That said, theyve done their job and I have no fear that theyll fall apart with normal road use

Put this on my Tusk tire carrier/rear bumper on my rzr. I use it to hold my shovel and it fit pretty dang nicely. Well worth the money and would buy again

Fits great, holds great, and my rigid light mounted with no problems.

I used to mount my helmet pumper. I did not use the factory holed but rather tapped a hole higher up for my purpose.

Works great for light bar

GREAT MOUNT

Stronger and better looking than I expected. I used these to relocate my front turn signals to the fork tubes on my motorcycle. at 1.5 (38.1mm) they are smaller than my 39mm fork tubes and I thought I might have to machine them to fit. By not using the included rubber pads, and tightening each side a little at a time, I achieved a perfect fit. If you want a high quality, great looking, sturdy P clamp, you wont be disappointed.

these worked great,got them super tight on bar.Thanks.

Well machined and anodized. These are very sturdy even with a 4 1/2 housing mounted onto them. The vibration isolation is excellent.

Broke after a few hours of use.