HOUSE TUNING Bar Clamps 2.25 inch -Pack 2, 2 1/4 inch Roll Bar Clamp Bracket,Led Light Mount Clamp,Roll Bar Mounting Brackets,Tube Light Mount for Light Bar (2.25 Clamp - Pack 2)

Fit on handle bars perfectly and light bar attached easily. Seem well made

I bought these to mount a shovel and traction boards to my 2019 4Runner. The 2 size is a bit too large for the factory Toyota TRD roof racks rails. I tried using inner tube rubber to make up the difference but that did not work out. The next day I bought a piece of 2 round rubber hose from the plumbing dept , I cut some slices off to match the width of the clamps to make up the difference in size and it worked fantastic. I then drilled 2 holes in the traction boards, ran a 6 carriage bolt through the clamp and 2 boards and put a nut and a threaded knob on the outside to ensure that they would not loosen up on the road. The other side has rubber adaptors to hold circular tool handles and my shovel is secure. Good deal, Recommended highly. Well made with a low gloss black crinkle coat.

My tubing diameter is 1.124 so I ordered the 1.125 size. House Tuning uses rubber spacers for size matching. The first set of spacers were too thick for my tubing (their inside diameter was 1.034) so ordered replacements. Same problem. Both boxes were clearly marked 1.125. There were no markings on the rubber spacers. Dont waste your time with this company. Buy from someone who can provide the size you ordered and matches that specified on the box.

I used these clamps on a pole mount that is sold by Starlink for their dish. These are the perfect diameter to securely hold the pole mount. I use the same companys 2 inch diameter clamps to attach to my travel trailer jack and then use bolt with lock washer and wingnut to secure the two clamps together Works great and is easy to assemble and disassemble when I want to take the Starlink dish and pole down to stow.

Not something I’d get again or recommend

Work great, can’t beat it for the price.

Very nice.

Perfect clamps that I used to mount a pair of Nilight passing lamps onto the highway bars of my Yamaha V Star motorcycle. Quality is excellent, and their color blends right in with my black Star. Also, thank you to sellers for the lightening-quick shipment! Much appreciated.

This item is very poor quality and anyone wanting a high quality clamp should look at an alternate brand. The tolerances are way off, so much that the two screws used to hold the cap are binding against the sidewall of the holes. Furthermore, the final inside diameter (when the screws are tight) is not symmetrical; therefore, causing an uneven clamping around the entire circumference of the clamp. The finish is not anodize or powder coat; thus these clamps will look terrible and begin to corrode within 4 months of install. No thanks.

Great product