INTELLIMADE, Acrylic Sheet Plexiglass 12 x 12 Square Panel 1/8 (3mm) Thick, Cast Plexi Glass Board with Protective Paper for Signs, DIY Display Projects, Craft and Easy to Cut, 1-Pack, Clear

The protective film made this product scratch free.

This is perfect plexiglass. I was making a frame with it, using glass on the front and the INTELLIMADE Acrylic Sheet Plexiglass on the back. After having assembled my frame, with the frame clips that I invented, I noticed that I liked the look of my artwork underneath the plexiglass, rather than the glass I used for the front. I will use the INTELLIMADE next time and ditch the glass.

The acrylic itself isn’t terrible however, it is not cut correctly and the sheet is not completely square like it should be. I probably will not be purchasing from this company again. If the uneven sides don’t bother you then have at it. It just became more work for me to fix on top of the project I was already doing.

Cuts great with a co2 laser. I do wish that it had a paper cover material rather than plastic as its hard to tell if you have removed it. The plastic cover also tends to shrink back leaving it useless as a paint mask.

Good quality! Much Better than I expected. I use as my tables cushion. Arrived packaged very well, no breakage or issues. Remembered to remove the protective film before using. After poll off the fim, very clear with no scratches. The broad is really sturdy, and I believe it is also pretty for a transparent panel. Strongly Recommond!

Cut to the size we needed, removable film coat so they didnt scratch when shipped, perfect for what we needed the two pieces for.

I was looking for acrylic sheet to do a small project for thanksgiving, this one is perfect! Much better deal than the local store! Will come back for more if I run out.

I like this product for camper windows. Very strong. Thanks.

In searching for inexpensive yet sturdy and easy-to-clean material for my mini mill bed covers, found this 2 piece set of Plexi-glass to fit my need-Score! Plex is always easy to cut, sands, and polishes nicely for the end product. I attached pieces of 1/2 aluminum channel to the bottom areas to fit into the T-Slots of the mill bed. The Amazon 5/16 magnets were inserted in end milled holes on the bottom side of the rear sections for a bit of additional holding power. This simple addition allows me places to set tooling and other stock on the bed, without damage or falling into the T-slots. Clean-up is so fast and easy now, no swarf in the T-slots, simply vacuum it off and done. The small magnets additional advantage is the collection of steel swarf, again easier for cleanup. I left the paper on the top side to eliminate slippage of objects placed on the bed, not falling to the floor.

Good value for the money.