Iverntech 6pcs 1M XH2.54 4 pin to 6 pin Terminal Stepper Motor Cables for 3D Printer Nema 17 Stepper Motor

Bought for Ender3 extruder motor. I followed the text that said swap middle wires, swap red/green...well after that didnt work right. So I ignored the text and arrows in the photo, and did a spot the difference. Turns out 3 wires needed to be repinned. Luckily it didnt short anything on my printer...directions to repinning were just plain wrong. At the end of the day, it works...but I wouldve preferred buying something plug and play or even just having correct directions/instructions.

As described

My Voxelab had been playing up for a while and I finally got time to look into why and noticed one of the exiting stepper motor cables had got damaged somehow. Initially tried ordering some new sockets but they were the wrong size so in the end, for ease, plumped for this direct replacement and it worked immediately. Problem solved. I didn’t need all four but I guess they may come in handy one day. A little expensive for a few bits of wire but I paid for the convenience.

Bonjour, Pour agrandissement fraiseuse Foxalien Masuter Fait le job (verifier les codes couleurs) Jai du inverser les 2 fils du milieux des connecteurs côté moteur.

We have been using them for a while now and they are holding up well. The connection to the phone is secure so if your phone falls down in the couch you can retrieve it by the cord. When not in use it periodically falls into the couch and I have to pull it out from behind and it never gets stuck on anything because of the molded plug end. The 10 length gives plenty of room to move about while plugged in.

PSA: swap the green and red wires on the end of the wire that goes into the stepper motor. Push down on the little tab on the top of each pin to release it from the connector. I didnt do this, and it made a terrible knocking sound. My poor stepper.

:)

I bought this thinking it was a 1-1 swap for my ender 3 pro. You need to swap the 2 middle pins on the 6 pin adapter. It took me a bit to figure out why my upgrade didn’t work. Other than that it works perfectly fine!

Forgive this review if I have misread the description (bear in mind it may have been updated since I purchased this product). Like many, many other listings (I have now discovered) - these cables commonly used in stepper motors are not JST XH connectors - at either end. Yes, one end has a 4 socket dupont connector. At the other end is a 2mm pitch - not 2.5 or 2.54mm pitch - JST style connector. Closest JST range appears to be the PH 2.0mm style. They do fit many stepper motors but if you actually want what is advertised - a 6 socket 2.54mm pitch JST connector - these cables will disappoint.

Ich habe keine Ahnung ob die Kabel mit anderen Schriet Motoren funktionieren. Glaube ich kaum. Die kabel sind doch normalisiert. God sei dank, habe ich weder Platine noch Schriet Motoren kaput gemacht. Glück gehabt. Aber beim kauf aufpassen. Man muss Stecker neu verkabeln. Deswegen nur zwie Sterne.