Iverntech 6pcs 1M XH2.54 4 pin to 6 pin Terminal Stepper Motor Cables for 3D Printer Nema 17 Stepper Motor

Bonjour, Pour agrandissement fraiseuse Foxalien Masuter Fait le job (verifier les codes couleurs) Jai du inverser les 2 fils du milieux des connecteurs côté moteur.

PSA: swap the green and red wires on the end of the wire that goes into the stepper motor. Push down on the little tab on the top of each pin to release it from the connector. I didnt do this, and it made a terrible knocking sound. My poor stepper.

Cercavo dei cavetti da 50cm per i motori passo passo di una prt 3D. La confezione include 6 cavetti, connettori ben attestati, possibilità di invertire i pin per adattarli alluso che se ne vuole fare. Rapporto qualità/prezzo/quantità ottimo

Ich habe keine Ahnung ob die Kabel mit anderen Schriet Motoren funktionieren. Glaube ich kaum. Die kabel sind doch normalisiert. God sei dank, habe ich weder Platine noch Schriet Motoren kaput gemacht. Glück gehabt. Aber beim kauf aufpassen. Man muss Stecker neu verkabeln. Deswegen nur zwie Sterne.

These were not wired correctly for the Nema 17 Stepper Motor on an Ender 3. I have a feeling it burnt out the stepper drivers on the board. It needs to be Blue/Green and Red/Black on the 6-pin connector.

Works

i damaged a cable on my monoprice mini delta and this was just what i needed to get it printing again.

Bought for Ender3 extruder motor. I followed the text that said swap middle wires, swap red/green...well after that didnt work right. So I ignored the text and arrows in the photo, and did a spot the difference. Turns out 3 wires needed to be repinned. Luckily it didnt short anything on my printer...directions to repinning were just plain wrong. At the end of the day, it works...but I wouldve preferred buying something plug and play or even just having correct directions/instructions.

Ottimi per collegare i motori lontani alla s heda di controllo.