Iverntech 6pcs 1M XH2.54 4 pin to 6 pin Terminal Stepper Motor Cables for 3D Printer Nema 17 Stepper Motor

Ottimo prodotto adattissimo allincisore EleksMaker A3

Achtet darauf das die Pole stimmen, ich hab gerade 2 Nema 17 gekillt. Hoffe das Motherboard hat es noch überstanden. Ich könnt im Strahl kotzen.

o produto correspondeu perfeitamente ao descrito; o envio foi rápido e a logística foi eficiente.

PSA: swap the green and red wires on the end of the wire that goes into the stepper motor. Push down on the little tab on the top of each pin to release it from the connector. I didnt do this, and it made a terrible knocking sound. My poor stepper.

I bought this thinking it was a 1-1 swap for my ender 3 pro. You need to swap the 2 middle pins on the 6 pin adapter. It took me a bit to figure out why my upgrade didn’t work. Other than that it works perfectly fine!

Well made cables, no issues. I’ve ended up shortening some of these to suit my printer but the length was really useful on the X axis (225mm Z height, 260mm X all in cable chains)

After fitting a direct drive extruder to my Ender 3 V2 I needed longer cables for the stepper motors and these were perfect. Decent quality and well made.

Works

works good but needs some tuning for a creality printer

My Voxelab had been playing up for a while and I finally got time to look into why and noticed one of the exiting stepper motor cables had got damaged somehow. Initially tried ordering some new sockets but they were the wrong size so in the end, for ease, plumped for this direct replacement and it worked immediately. Problem solved. I didn’t need all four but I guess they may come in handy one day. A little expensive for a few bits of wire but I paid for the convenience.