LCD Screen Separator Machine, 7 Inch Screen Repair Separating Machine Touch Screen LCD Glass Lens Removal LCD Separator for Cellphone Ipad Repair, Build-in Pump

My husband wanted this to fix some electronics in our house. This worked perfectly to soften the glue to take screens off and to heat it up to apply a new screen.

this machine has no uniform temperature. set it to 80 C, top parts gets to over 100C and stay there while bottom stayed at 79 to 81. so to me its not useful at all. useless in this case. look for other machine.

Great machine great for the job. It will hold the device to replace the screen. Great machine

As others have said, its pretty inconsistent with the heating element, one side does get hotter. For $45 I cant really complain, it helped me with my iPhone screen repair.

Used it to remove the back panel off my S8 to replace the battery. Was perfect for the job. Simple to use and effective. P.S> Amazon asks me to rate its Thickness and I just have to say, She Thicc.

Excelente para realizar el cambio de pantalla del celular que gustes

Very happy my purchase

Terrible

This is a usable product but read this first before buying and decide if its for you. As you can see from the photos it does not come with the L brackets in the photos in the ad. So its a misleading ad. For 500W usage it sure takes a while to heat. Almost a minute or two. My printers using 120W beds heat up faster with a bigger surface area and less voltage, go figure. Probably not 500w. When set to 65C the front of the unit where the heater obviously is got to 72C. The rear got as hot as 68C. This was while the pump was running. This is BAD because it NEEDS to be uniform across the plate. If too cold it wont cut glue and if too hot it can damage the screen. Each phone has its own temps based on the manufacturer. Having a 4 degree Celsius or 7.2 degree Fahrenheit hysteresis across the surface can be risky as far as risking damaging a screen while still being able to cut through the glue. I am upset because I could have made something better from 3D printer parts I have. Just having to order a 12$ pump on ebay and drill some old printer bed. So make sure if you use this to set it lower than needed by about 5C. I cross checked this against my multi-meters thermistor and a thermistor from a 3d printer which I know is 200% accurate. Just dont lower it too much or your wire will start snapping from cold glue and can pull the phone off the unit from fighting the cold glue too much. Almost guaranteeing your failure or breaking parts. If you find yourself fighting it, turn it up 2 or 3 and wait. Also keep the phone towards the upper/cooler part of the plate to reduce risk of accent paint, digitizer, or LCD damage. They have this on other auction sites for 45$ free shipping. Only got it here cause I had a gift card. Hope this helps someone

Works as advertised