Lift Supports Depot Qty (1) Fits Crossfire 2004 To 2008 Hood 5101653AA PM9032 SG103002
-
Mike H.
> 24 hourYou verified that this was the right item to fit my specific car. Thank you
-
Mparks
> 24 hourPerfect fit, installed in 20 seconds!
-
Cynthia Gettler
> 24 hourWorked just like the OG one.
-
Todd linam
> 24 hourFit like a glove
-
Diann Grigsby
> 24 hourPerfect fit. Replaced the old support by myself in about 1 minute.
-
rachel trujillo
> 24 houreasy to install
-
Richard
> 24 hourCame complete, easy install
-
JPM
> 24 hourExact filter as MB uses in Crossfires SRT Engines
-
Candy Koontz
> 24 hourGreat quality and easy to install . Would buy again if ever needed
-
Smartbuyer
> 24 hourWay cheaper then dealer, or parts store! Works great!
Why Purchase from Lift Supports Depot?
|
|
|
|
|---|---|---|
Premium Quality SupportsLift Supports Depot supports undergo a vigorous QC process to help ensure dependability. Lift supports internal components get assembled and mechanically tested to ensure internal parts are not installed incorrectly or missing. OE quality seals are incorporated to prevent low friction losses and oil seepage. Airline hydraulic oil helps to avoid crystallization and blockage during cold weather. After painting and curing, lift supports are tested again for pressure and printed with final product information and lot numbers for traceability. |
Vigorous Quality Control ProcessThe supports are pressure-filled and tested one by one for forces to be within accepted tolerances. Pressurized lift supports go through a pre-paint phosphate treating process, which helps the paint adhere properly to the body of the lift support and gives a long paint life. Most importantly, an automated paint cabin is used for painting and curing in one place. Our lift supports never have premature rusting at the extremities due to the capillary effect of paint in bent areas. |
Easy to InstallMost applications are quick and easy to install. Often times requiring nothing more then a flat headed tool to remove and replace. The hardest part is often finding someone to hold the Hatch or Hood while you swap them out. |
Insert a Flat Headed tool behind the U-Band.
Slightly Pull Back on the U-Band, allowing the claw to release the ball stud. Careful that you do not remove the U-band from the Support.
Place new support over the ball stud and press the ball socket over the ball stud.
Once this has been completed for all mounting points, carefully tug to ensure all ball sockets are secure on ball Stud.