Lift Supports Depot Qty (2) Fits Camry 2007 To 2011 Front Hood 10030744 200186 24761 5344006050 53440-06050 5344006050B 5344006051 53440-06051 5344006052 53440-06052 5344006060
-
kghaf
> 24 hourworks great and it arrived earlier than expected. it was easy to install.
-
Earl
> 24 hourNo hassle replacement if there are any problems.
-
Da ha y n
> 24 hourHeadline says it all
-
Jean Carlos Aray
> 24 hourExcelente
-
Jules
> 24 hourThey are a perfect fit!
-
Kyler Huel
> 24 hourGreat!
-
DCheco
> 24 hourFit perfectly!
-
MARGARET A.
> 24 hourEasy to install. I didnt think it will last for the price but seems solid.
-
K. Young
> 24 hour. . . at much less cost than OEM. Easy to install too.
-
Mr Impulse Purchase
> 24 hourQuick install. I would recommend propping a paintcan or some other wedge under the hood to keep it fully open during installation. Took more time getting the old ones off than the new ones on.
Why Purchase from Lift Supports Depot?
|
|
|
|
|---|---|---|
Premium Quality SupportsLift Supports Depot supports undergo a vigorous QC process to help ensure dependability. Lift supports internal components get assembled and mechanically tested to ensure internal parts are not installed incorrectly or missing. OE quality seals are incorporated to prevent low friction losses and oil seepage. Airline hydraulic oil helps to avoid crystallization and blockage during cold weather. After painting and curing, lift supports are tested again for pressure and printed with final product information and lot numbers for traceability. |
Vigorous Quality Control ProcessThe supports are pressure-filled and tested one by one for forces to be within accepted tolerances. Pressurized lift supports go through a pre-paint phosphate treating process, which helps the paint adhere properly to the body of the lift support and gives a long paint life. Most importantly, an automated paint cabin is used for painting and curing in one place. Our lift supports never have premature rusting at the extremities due to the capillary effect of paint in bent areas. |
Easy to InstallMost applications are quick and easy to install. Often times requiring nothing more then a flat headed tool to remove and replace. The hardest part is often finding someone to hold the Hatch or Hood while you swap them out. |
Insert a Flat Headed tool behind the U-Band.
Slightly Pull Back on the U-Band, allowing the claw to release the ball stud. Careful that you do not remove the U-band from the Support.
Place new support over the ball stud and press the ball socket over the ball stud.
Once this has been completed for all mounting points, carefully tug to ensure all ball sockets are secure on ball Stud.