Micro Swiss Plated Wear Resistant Nozzle for Creality CR-10S Pro/CR-10 MAX Original hotend ONLY (M6x.75mm Threads) (.4mm)

Did not fit the CR-10 S5, even though it says it fits the CR-10. Its been a busy couple of weeks and wasnt able to install it right away. Now its past the return window and cant return it. They should put that its NOT for the S5

This nozzle was great. Accurate diameter, and handled wood fill filament without any wear. Heat transfer as good as brass, none of the worries of steel.

works :)

I used this to replace the stock nozzle, which had worn out after running who knows how many rolls of PLA through it. I can confirm that this is for the CR10S Pro, and that installation is a breeze. I am seeing high quality prints once again thanks to this nozzle, and with any luck, I wont have to worry about replacing the nozzle for quite some time.

If you have a CR10S Pro and want to print abrasive materials, this is the nozzle you need. No need for a different hotend or extensive mods, this directly replaces the factory nozzle.

Good quality and good lines.nNonissues at all with Micro Swiss nozzles.

great

Great nozzle tip, I now am trying to give my brass tips away, this tip has over 300 hours with NO Wear

This nozzle fits the M6 x75mm (fine thread) hot end used by creality on the CR10s pro. If youre looking to replace a micro swiss nozzle this isnt that. This is a micro swiss brand replacement of the stock unusual sized nozzle. I swapped nozzles with no issues and extruded 100mm of filament. Result .4mm +/- .02mm measured every 10mm along the extruded plastic. The variance is to be expected based due to inconsistency in the cheap filament Im using. The .4mm nozzle is .4mm no complaints :) If Im happy with this nozzle I might pull the trigger on the $65 drop in replacement all metal hotend from micro swiss so I can buy standard nozzles.

great stuff