PGN UCP205-16 Pillow Block Bearing - Pack of 2 Mounted Pillow Block Bearings - Chrome Steel Bearings with 1 Bore - Self Alignment
-
Tim
> 24 hourI have two sets of 1” under a heavy load and they are solid
-
Bill
> 24 hourJust what was needed to complete project. Thank you.
-
J. Sullivan
> 24 hourEvaporative cooler blower bearings are bronze sleeve type with the shaft forming the other bearing surface. It required monthly oiling and since there isnt a dirt seal, the bearing wear out after a years use. Replacements are about $16 a pair. These bearings are ball bearing type, grease every couple months, have seals and will last many years. They are not bolt-in replacement, but worth the effort. At this price, the manufacturer should build this way.
-
Flyer
> 24 hourThese bearings are a good value. They fit well. My problem is they will not withstand impact. The bases are cast material and brittle. I had suspected that would be the case, but was willing to try them. Four rifle shots into the morning and the target would no longer spin.
-
Emilio Braun
> 24 hourThey worked
-
Preston
> 24 hourIm using these bearings for a steering Colum, I understand this is an odd use case but while adjusting the angle of the bearing they fell out of the housing a lot of times. This caused me to have to weld up some weird angled brackets to make sure the bearing dont just fall out and loosen my steering shaft at 50 MPH. Figured this might be helpful for someone, good product otherwise.
-
Rodney Johnston
> 24 hourSturdy and consistent in machining.
-
Koala Bear
> 24 hourExact fit on a 26 year old machine. Allen locks to hold the shaft from walking. Grease fitting to keep it all lubricated. Great product.
-
John Gallimore
> 24 hourWorked just like they are supposed to. Quiet and replaced the original perfectly. Priced great
-
Pacaw 66
> 24 hourUsed as part of my attic lift. MUCH heaver than I needed but couldnt beat the price. I will never approach even 25% of their capacity. I like pillow bearings as they are self aligning [dont have to have each bearing EXACTLY on the same axis] ONLY con, they were about .0015 UNDER size, had to lap the shaft a bit to get it to fit. Would recommend for anyone building a lift requiring bearing supports.
