PGN UCP205-16 Pillow Block Bearing - Pack of 2 Mounted Pillow Block Bearings - Chrome Steel Bearings with 1 Bore - Self Alignment

Evaporative cooler blower bearings are bronze sleeve type with the shaft forming the other bearing surface. It required monthly oiling and since there isnt a dirt seal, the bearing wear out after a years use. Replacements are about $16 a pair. These bearings are ball bearing type, grease every couple months, have seals and will last many years. They are not bolt-in replacement, but worth the effort. At this price, the manufacturer should build this way.

Solid bearing, its able to adjust slightly which is really good for less than perfect installations. Reviewers mention its crooked which is silly because you just it adjust it to fit and it stays perfectly straight, thats the whole point. Im using mine on a garage door spring bar to keep the ends from moving up and down as the bar flexes and bends. This bearing is Perfect for this since it adjusts, like its suppose to, to point in the correct direction and keep the movement up and down in check.

Good product

I bought two pairs for a cable dolly. The idea being to have the heavy roll sitting between two rods which turn freely using the PGN ball bearings. So far so good. they work nicely and are easy to align. The only problem is that they dont turn easily but are rather stiff. There are no instructions how to lubricate them and get them going easily. In the end I used a bit of lubricant for bicycle chains and that helped a little bit - but still not rotating as freely as expected. Update: I have ordered a grease gun and will amend if the situation changes

Should have read reviews. Bearings both came not correctly pressed into cast housing. Requesting a refund and if excepted I will a have to wait almost two weeks according to my request form

Looks nice

Complete garbage. I bought four bearings. All of them were set in the housing completely wrong. Off by about 15°. If it were just one I could understand maybe but all four are useless.

Just what I needed for replacing the old pillow blocks for my 20 rock saw with something heavier duty and greaseable!

Im using these bearings for a steering Colum, I understand this is an odd use case but while adjusting the angle of the bearing they fell out of the housing a lot of times. This caused me to have to weld up some weird angled brackets to make sure the bearing dont just fall out and loosen my steering shaft at 50 MPH. Figured this might be helpful for someone, good product otherwise.

Worked just like they are supposed to. Quiet and replaced the original perfectly. Priced great