RCBS Single Stage Shell Holder, Hardened Shell Holder for Reloading on Single Stage and Turret Presses

Its working good

As expected

I like to have more than one shell holder for the calibers that I reload most often, (pistol cartridges) This way I can keep one on my hand held priming tool and one on my turret press, also one for my single station press to pull bullets, etc. Its a big time saver for my reloading process.

A must-have for reloading 5.56, 300AAC Blackout, etc. There doesnt seem to be a good list on the RCBS site regarding which calibers the shell holders take, but for what I use, they fit perfectly well. Beware messed up heads on reloaded cases. If they slip off the shell holder and the shell-holder rips the head off, you WILL have a fun journey removing the case from the die body... Trust me... Be gentle.

As advertised

I can not beleive some Die makers fail to include a shell holder in their die sets. Is there a reason besides the obvious? Anyway this sheel holder works for 38, 357, etc.

The quality is as good a Hornady. I wish that the priming hole was the same size as Hornady; that is my only complaint. Otherwise it works quite with my Hornady Lock n Load equipment. Normally, I would have purchased Hornady, but the one listed for Hornady was the wrong description, and was sent one for a .40 cal. I can use it so I did not send it back, and just went ahead and ordered the RCBS. Again, my only complaint is that the priming hole is smaller than Hornady.

Excited to finally have dies for my Mauser

Used these dies for my Yugo 8mm Mauser. Rcbs dies are the best value dies in my opinion.

Top quality. RCBS top of the line reloading products