RCBS Single Stage Shell Holder, Hardened Shell Holder for Reloading on Single Stage and Turret Presses

Great Price and fast shipping

If you need one of these, you know what you are looking for. RCBS is always great and the quality is top notch!

This shell holder will work great, thats what you expect from RCBS.

Fits great and is as described

This will universally work in assorted manufacters presses

I use it on a Lee press and it is a little bit snugger inside than the Lee shellholder #4 that it matches. In my case, when using it for 380 that is a good thing because the #4 Lee isnt quite tight enough when used for the 380, a caliber listed for this shellholder. It saves a few 223 and 204 cases as well because it grips the rim a little better which comes into play when a case is somewhat stuck in a die but can be gently extracted if the rim holds up. Your chances are better with this die.

Works perfectly. Had a Lee shell holder that came with the Lee die set for .223 and it was bad. Not machined out fully and the shells didnt go all the way in. Then I purchased one from CH4D along with there swage removal die and it worked but was to tight inserting and pulling out the shell and would leave a gouge in the case. Tossed them both and bought the RCBS. Highly recommended!

Works without question.

I got a used lee shell holder for .223 and it was soo loose while resizing military crimped brass it kept ripping right off the head of the brass. This held the head way tighter and I didn’t get anymore brass stuck in the die.

As expected