Ultrasonic Cleaner Solution for Carburetors and Engine Parts, Ultrasonic Cleaning Solution and Washing Compound for Ultrasonic and Immersion Washers - Concentrated (32 Ounces)

Im using this in a large amazon ultrasonic cleaner. I mixed it 1 gallon of solution to 3 gal of water. Its cleaned 4 mower carbs, a 4 set of motorcycle carbs, and now 3 dozen dirty V8 rocker arms. Stuff is still working great. I drain. It and use a paint strainer after every use. Still green.

Fast shipping and work good

Used in ultrasonic cleaner to clean tractor carburetor. Product worked well.

As you can see the photo it cleans very well

It doesnt turn your aluminum grey. I use it lightly 1-9 instead of 1-4

The only thing I had trouble with is the directions on mixing its very vague and not easy to understand. What is do like is how easy once you figure out the directions it is to use and how well it Cleaans.

Its great for cleaning up the parts. I hed a carb from my granddads tiller that looked like the dirt I was tilling on the inside. Cleaned it up and now it runs like new. Would definitely buy again.

I am utilizing it to clean mechanical parts with my ultrasound cleaner. I utilized a 50/50 proportion with water. Did quite well. Heavy carb built up, I just ran it 2X and it did the trick. Would recommend

I tried this product and used the water to solution ration that was recommended after the effective solution I was buying from Amazon wasnt available. I had the water temperature HOT. This solution didnt do much for melting/removing light surface dirt or grease. I added more solution to see if that would make it effective. It did nothing to help remove it. So, I wouldnt buy this solution for an ultrasonic parts cleaner if youre trying to clean and remove oil/grease and other things from carbs or fuel pumps.

Says to mix 5 parts water to 1 of the product. I needed to clean a 40-year old Super E plus the backing plate and the manifold - looked like theyd never been cleaned before - baked-on stains inside and out. I heated the mix to about 60C before dropping in the parts, then let it run it for 40 minutes. Everything came out sparkling, brand new looking. I wont use this every time but for parts with years of caked-on dirt and stains it was well worth it.