Uniden BC-UTGC GPS USB Cable for use with BCD325P2 Handheld TrunkTracker V Scanner, SDS100 True I/Q Digital Handheld Scanner and BC-GPSK Serial GPS Receiver

Worked perfect for hooking up a gps puck to my sds100 scanner.

Awesome plug. Hooked up the GPS Antenna to my Uniden BearCat BCD325P2 Scanner without any issues. Took a few minutes the first time, but after that it is almost immediate!

Use this cable on my Uniden SDS100 scanner and external GPS module and that combo allows the scanner to follow public service frequencies based on my location.

No dislikes, cable does exactly what I was expecting.

Worked for about a month, then started failing and may have caused the control board in my radio to fail. Maybe just a bad unit, but cant recommend at this point. Problem started with low serial bus voltage message while in use. Disconnected GPS puck and message still there. Figured it out too late to save the $800 (after upgrades) radio.

Used it on a trip. Repeatedly received a USB low voltage error message. I had to wiggle the plug that goes into the scanner for it to come back on. I checked it with another plug and work with no issues.

Only way I could get the correct connector on the scanner end. Cut the USB end off to make a custom cable.

Got it very fast,a lot faster then I expected. Just as advertised and a lot cheaper then other places

Plug and play set the baud rate to 4800 and let the GPS communicate with the scanner. Works seamlessly.

Did not effect battery life I had it powered up