WindyNation 4/0 Gauge AWG (6 Feet Black + 6 Feet Red) Power Inverter Battery Cable Wire Kit for DC to AC Inverters RV, Car, Solar, Marine, Off-Grid

Installed a new trolling motor on my 17’ Bass Pro and needed to increase the wire size from #8 to # 6 AWG. The wire was the correct length to go from front to back. I soldered all electrical connectors to reduce corrosion.

Great product! Wire is nice n flexible. It wicks up the solder great. Perfect for dual battery setup. Also used for remote location jump start battery runs. The rubber is thick enough to protect. Windy nation is awesome !

This purchase was a pleasant surprise. I had two rolls of wire, in my basket and found this kit for less than just the wire. The lugs are very thick, high quality and they provide four each of two lug sizes! It also includes a ground wire and heat-shrink tubing. I bought this for my camping trailer that I use off grid. The only thing I would caution anyone about is using this for marine applications. The cable is copper but it is not tinned. Over time non marine grade wire will fail. I highly recommend it for land based applications.

Great wire. My only thing is the insulation is of the type that its hard to keep clean. Not slippery. If you get grease/dirt on it, it will be difficult to remove.

WORKED GREAT FOR POWERING UP MY 24V MOTOR GUIDE XI5 HAD ALL CONNECTORS I NEEDED

I got tired of the 20 dollar jump cable from big stores. last time, it wont even jump a 650cc motorcycle from 15 feet. so I decided to make my own with excessive specs, which lead me to choose this big thick cable. It looks good, well built, and the copper is thick! only downside is it is heavy(which is a good sign), but i am sure it will jump start any vehicle i have in garage.

Hasta el momento esta funcionando muy bien.Me hubiece gustado el manual fuese en espanol tambien y no tan pequeño,hay que utilizar una lupa para poder leerlo.

cam with lugs and grounding wire. used for my inverter excellent.

Used the 6 guage cabling to splice into my 10 guage trolling motor cables, then run to the back of my 17 ft bass boat without issue. The lugs and heat shrink were great (but always buy more of both.) The smaller jumper cables lugs were too small for battery terminals so I bought a short pre crimped replacement, but otherwise exactly what I needed.

I needed 2AWG for a battery relocation project on my off road truck. Local supplier gets $5 a foot. That would have cost me $150. I paid about a third for this kit and I got good qaulity terminal ends to boot! Inslulation is high quality and tough, good as any I have seen. Do not hesitate to buy, no worries, good product.