Yonico Router Bits Slotting Cutter 1/16-Inch 1/4-Inch Shank 12101q

Similar experience to others. Warped, burned and one tip flew off. Disappointing.

routed groove to install edging on melemine faced particle board

Nice construction and very clean slot cutting. Used it to make slots for installing polycarbonate glass into an indoor French windows.

This is nice tool but it failed after very little use. The problem is that the cutter is installed upside down so it was running backwards. I didn’t realize the issue until after it overheated and one of the carbide cutters came off.

Took it out of the pavkage.finished my project.zero wear. Cut ash like it was butter

Made a nice clean cut even through cedar.

EDIT: last of the two blades dislodged halfway through the 4th panel i used it on. This is a total turd, with the blades held on by one tiny little tack of weld, and goobers of paint. bought this to make t molding slots on 3 melamine arcade control panels. blade tip broke off halfway through second panel. really? particle board? buy something else.

BIT WORKED OUT PERFECTLY

Cut/router just over sixteen feet of redwood for my project. it’s accurate and barely notice any wear, even the yellow paint still on the bit. no burning.

No issues with it. Cuts a very accurate groove with ease. Bit is very well machined and put together. I probably wont use it enough to wear it out but I am impressed enough that Im going to try some of their other bits that I use more often. Recommended.